What Else is Needed to Install a Tekonsha Brake Controller # 39510 on a 2003 Toyota 4Runner
Updated 04/25/2013 | Published 05/26/2011
Question:
I have a 2003 Toyota 4-Runner with a factory installed hitch and 7 wire trailer wiring receptacle. I am interested in your electric brake controller, but did not see if I needed a relay, or anything extra... Please advise. thanks
asked by: Jeff N
0
Expert Reply:
With this Tekonsha Voyager Proportional Brake Controller # 39510 you will also need harness # 3040-P, to make it functional on your 2003 Toyota 4-Runner.
You will simply plug the included adapter into the back of the brake controller and then plug the other end into the port underneath the dash and you will be good to go.
expert reply by:
Jameson C
0
Continue Researching
- Q&A: Parts Needed To Add Electric Drum Brakes To A Trailer
- Q&A: Can Electric Over Hydraulic Brake Actuator Be Fully Submerged
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Adding Electric Over Hydraulic Disc Brakes to Boat Trailer
- Q&A: Parts Needed To Replace Surge Coupler For Disc Brakes With Electric Over Hydraulic
- Q&A: Differences Between Marine and Standard Hydrastar Actuators
- Q&A: Recommended Actuator and Wiring for Boat Trailer Upgrade From Surge Brakes
Phil B.
4/8/2013
Will this work on a 2010 FJ Landcruiser with a factory tow hitch?