Will Curt Hitch # C12272 Require Any Trimming of the Rear Fascia on 2006 Chevrolet Malibu
Updated 05/16/2011 | Published 05/13/2011
Products Featured in This Question
Question:
Will Towing Hitch #c12272 Fit my 2006 Chevy Malibu and will the rear bumper have to be cut into, for it to fit. Thankyou for any info.
asked by: Chas-O
Expert Reply:
The Curt Class II 1-1/4 Inch Hitch, part # C12272 will fit your 2006 Chevrolet Malibu. When installing this hitch on your Malibu, you will need to do some drilling, but you will not need to cut the fascia or rear bumber. The exhaust must be temporarily lowered during installation.
I am including a link to the installation instructions on the Curt Hitch # C12272.
If you will be towing with this hitch you will also need the following items.
Curt Drawbar # C45521, pin and clip # F-4, Tow Ready 2 Inch Hitch Ball, part # 19258, or Tow Ready 1-7/8 Inch Hitch Ball, part # 19256
Draw-Tite Wiring Harness, part # 18252
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: RV Storage Cover For a Riverside Retro 135 Travel Trailer With Rear Entry Door
- Q&A: Recommended 5th Wheel Hitch for MORyde Orbital Pin Box on 2019 Forest River Arctic Wolf
- Q&A: Is Drilling Required to Install Curt Trailer Hitch Part # C12272 on 2005 Chevrolet Malibu Classic
- Q&A: Inside and Outside Diameters of Bulldog # BD500212 Replacement Gear Set
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Looking For RV Range To Replace Dometic R2131-BBPFBO
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor