Replacement Air Lift WirelessOne Remote Will Not Work
Published 07/14/2017
Question:
Received the product. Purchased and installed new batteries. Will not come on. Product appears defective unless you can tell us what we need to do. Thank you
asked by: Steve R
Expert Reply:
The Replacement Remote for Air Lift WirelessONE Compressor System for Air Helper Springs # AL72704 needs to be synced.
To sync the remote use the following steps:
1. Turn ignition on.
2. Locate the sync wire in the wire harness. It will be the yellow wire that is looped with a yellow cap around it.
3. Remove the yellow wire from the cap leaving the cap attached to the harness.
4. Disconnect power to the receiver. Unplug the connector on the top.
5. Connect power to the receiver while grounding the sync input.
6. Listen for 3 clicks of the internal solenoid, then one click every second. This will indicate that you are now in the “sync mode”. Sync mode will last for 30 seconds total. Within the 30 seconds press any button on the transmitter to send a message to the receiver. Once the receiver has received a message it will sync with that transmitter and stop clicking the solenoid in 1 second intervals.
7. Reinsert the yellow wire terminal into the molded cap.
Continue Researching
- Q&A: WirelessONE Remote Replacement for First Gen Kit
- Q&A: How To Pair an Air Lift WirelessAIR Remote to Compressor
- Shop: Replacement Remote Control for Air Lift WirelessONE Compressor System