Dimension Of The Polar T-Strap Hinge For Trailer Doors
Question:
In regards to Item #PLR3408-SS can you tell me how wide the flat part of the bracket is only the flat part. I know it says the bracket is 1-5/8, I am assuming that includes the pin width as well? Thank You
asked by: Ken
0
Expert Reply:
The T-Strap Hinge for Side and Rear Trailer Doors - 8" Long - Stainless Steel # PLR3408-SS is a nice corrosion resistant hinge. The measurement you asked for of the flat part of the bracket is the 1-5/8 inches you mentioned. If you include the pin it is about 2 inches. You can see these measurements in the attached video as well as a few others you may find helpful.
expert reply by:
Jason S
0
Product Page this Question was Asked From
T-Strap Hinge for Enclosed Trailers - 8" Long - 180 Degree Rotation - Stainless Steel
- Trailer Door Hinges
- Strap Hinge
- T-Strap
- Stainless Steel
- 8 Inch Long
- 2 Inch Wide
- Bolt-On - Pre-Drilled Holes
- Polar Hardware
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Bolts Are Needed For Installing T-Strap Hinge # PLR2008-SSP on a Trailer?
- Q&A: Replacement Door Hinges for a 1990 Sooner 2H Slant Horse Trailer
- Q&A: Recommended Replacement T-Strap Hinge for a Toy Hauler
- Q&A: Can I Install Brakes On Only One Axle Of A 2 Axle Trailer And Which Axle Should They Go On?
- Q&A: Three Hinges To Hold Large SST Door 10 Foot Tall By 6 Foot Wide And Approximately 800 lbs
- Q&A: Is There a Replacement Door Latch for a 2007 Rage N' Toy Hauler
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Article: Where to Position the Trailer Axle?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer