Will Rear Center Fascia Be Reinstalled When Installing a Trailer Hitch on a 2014 Cadillac SRX
Updated 04/12/2017 | Published 04/11/2017
Products Featured in This Question
Question:
This is going on a 2014 Cadillac SRX. The panel on the bumper is shown removed for install is this able to go back on when not towing?
asked by: Charlie H
Expert Reply:
Per the installation instructions, all of the hitches available for your 2014 Cadillac SRX, including the Curt # C12070, will require the removal of the center rear fascia. This will not be re-installed due to the space that the hitch takes up.
Keep in mind that the Curt Class II hitch # C12070 requires the use of a stabilization strap, like part # 18050, with non-trailer loads like bike racks, cargo carriers, and the like. Failure to do so will result in a voided warranty per Curt.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 350 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Difference Between The Curt & etrailer Class III 2 Hitch Receiver
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Difference Between Curt and etrailer Trailer Hitch Receivers for 2020 Chevy Colorado
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Can the Center Knockout Panel be Re-Installed After a Trailer Hitch on a 2015 Cadillac SRX
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: How to Determine Towing Capacity for a 2014 Cadillac SRX
- Article: Trailer Wiring Diagrams
- Q&A: Curt vs. etrailer Trailer Hitch For 2016 Cadillac SRX
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Q&A: Recommended Trailer Hitch Receiver and 4-Way Vehicle Wiring Harness For a 2024 Kia Sportage Hybrid