What Material Is The Body Made Of On The Pollak 2-Pole Socket Connector # PK12801
Published 01/14/2011
Question:
Is the body of the above referenced part made of metal or plastic? What particular material is it made from?
asked by: Greg K
0
Expert Reply:
The body of the Pollak 2-Pole Socket Connector - Vehicle Side, part # PK12801, is made of cast aluminum.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
2-Pole Socket Connector - Vehicle Side
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 2 Pole
- Plug Only
- Pollak
more information >
Continue Researching
- Q&A: Do 7-Way Trailer Connectors have Amp Ratings for Pins or the Whole Socket
- Q&A: Electric Boat Trailer Winch With Remote Capable Of Pulling 3,000-lbs
- Q&A: Recommended Electric Winch With Remote for Boat Trailer With 8,000 Pound Grady White Gulfstream
- Q&A: Methods for Powering Electric Winches
- Q&A: Winch Battery Recommendation for 3000-lb Winch with 170 Amp Draw
- Q&A: Looking for Replacement Distribution Panel for IOTA IDP-30
- Q&A: Class 4 Hitch For A 2024 Chevy Silverado 1500 Without A Factory Hitch
- Article: How to Measure for Motorhome Steps
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Lighting Requirements
- Article: Determining Trailer Tongue Weight
- Article: Most Popular Wheel Bearings