Running Wires For Hopkins Backup Camera To Mount On Front Of Vehicle

Published 01/19/2017

Products Featured in This Question

Hopkins Smart Hitch Backup Camera and Hitch Aligner System

(842)

$190.15

In-Line Circuit Breaker - 20 Amp - Perpendicular Mount Bracket

(100)

$5.13

14 Gauge Primary Wire - Black - per Foot

(47)

$0.55

Pollak Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - Black

(16)

$13.93

Universal-Design Rocker Switch - SPST - On-Off - 12 Volt - 20 Amp - 3-Blade - Red Pilot Light

(12)

$10.88

Pollak Medium-Duty Toggle Switch - SPST- On-Off - 12 Volt - 20 Amp - 11/16" Handle

(21)

$6.46

Question:

Can I install this camera in front bumper where the license plate was mounted so I can use it to park and see the distance from the car in front of me

asked by: Danny

Expert Reply:

In order for you to be able to use the Hopkins Smart Hitch Backup Camera, part # HM50002 as a camera and monitor, you will need to cut the plug off the end and hard wire the system.

If you are going to use it for the front I recommend running the red wire to the battery and use a switch. You will need additional wiring like part # DW07550-1 to reach the switch inside of the vehicle. This is sold by the foot. You will also need to secure the white ground wire to a clean bare metal surface.

For a single pole/single throw switch for 12V DC systems I recommend part # PK34308. If you prefer a switch with a Red pilot light I recommend part # PK34360. These are rocker design switches. If you want a toggle switch for your lights I recommend part # PK34571.

You would attach one side of the switch to the red wire from the camera. Then run a wire from the other side of the switch to a 20 amp circuit breaker like part # 9506P, and complete the wiring by running a wire from the breaker to the positive battery post.