Draw Tite Hitch that Fits 2001 4Runner SR5 4WD
Updated 12/12/2016 | Published 12/11/2016
Products Featured in This Question
Question:
Looking for a hitch that would require least extra labor and/or tools for assembly, and would fit my vehicle without modifications if possible. Havent found anything that specifically says it will fit my vehicle, but I have read that 01 4Runner and Tacoma have same frame and hitch mounts could be essentially interchangeable between these two vehicles. I have found a few mounts that claim to fit the 01 Tacoma without modification: I dont think you carry all of these, but please advise which options would fit my 01 Toyota 4Runner sr5 4WD, and with least extra drilling or mods needed. Thank you!
asked by: Sarah
Expert Reply:
For your 2001 Toyota Tacoma we have the Draw Tite hitch part # 75078 as realistically the easiest fitting hitch that is a confirmed fit. The bumper does need to temporarily come off but it's more of a time consuming aspect vs. a difficulty type thing.
This is the only hitch of the ones you listed which I can guarantee as a fit.
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- 5000 lbs GTW
- 9000 lbs Line Pull
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How Much Ground Clearance Will Be Lost With C31013 Installed On Vehicle
- Q&A: Stealth Hitches Hidden Trailer Hitch Receiver for 2020 BMW X7
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: Dimensions Of Curt 31408, Draw-Tite 65080, and Draw-Tite 64079 Front Mount Trailer Hitch Receivers
- Q&A: Dimensions of Curt Front Hitch C31013
- Q&A: Best Base Plate for my 2003 Toyota Tacoma and my Roadmaster Sterling Tow Bar
- Article: Redarc Tow-Pro Elite Full Review
- Article: Stability Control for Heavy Duty Vehicles