Unloaded an Loaded Height of the Leaf Spring e77SR

Updated 10/03/2016 | Published 10/01/2016

Question:

What is the Camber? Which I understand is the vertical measurement at No-Load from the center-top of the spring to the imaginary line from center eye to eye. You should be including this basic important information with ALL your leak springs as it helps a person understand clearances to the frame from where the axle hardware is expected to be!! Do you have any information what the Camber would be if the 2,000 lb. trailer which had proper weight distribution at the 2000lb GVWR? Another words when it is at its designed 2000 lb. load what is the camber at that point? I understand there is also shock-load parameters after the full load rating, but Im not asking for that. This information is critical information that I must have to purchase. Thanks !!

asked by: Bob T

Expert Reply:

The dimension you are looking for is 4-1/4 inches on the part # e77SR.

Typical spring deflection is up to 1-1/2 inches when at capacity. So that would change the dimension to 3 inches.

expert reply by: Jameson C