How to Pick Out Landing Gear for 1997 Avion Wesport by Fleetwood  

Question:

Expert Reply:

In order to pick out a direct replacement for the landing gear on your 1997 Fleetwood Avion we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Bulldog Tandem Landing Gear Set # BD500162. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed and then install the brackets of the # BD500162.

The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.

If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.

expert reply by: Jameson C

0

Mike M.

7/20/2020

Have avion with 24 inch bracket spread as measured by your diagram. Need 12 thousand pound lifting capacity. Per your sight you 20 1/2 spread. Do you have one that will bolt up to original. A contact phone on your website would be a plus

Chris R.

7/24/2020

The Ultra-Fab Landing Gear Set # UF17-943010 is the only 12K rated system we have available. You could still use this as a replacement but you'll just need to remove the existing brackets and replace them with what comes included with the set.