Replacement Poly Bushings for Rear Anti-Sway Bar on a 2011 Tiffin Allegro on a Ford F-550 Chassis
Published 09/22/2016
Products Featured in This Question
Question:
I have a 2011 Tiffin Allegro MH with F550 chassis. I measured sway bar and it is 1-27/64inch in diameter. Will this kit work? I found lower bolt on driver side missing form factory bushing.
asked by: Eric G
Expert Reply:
Rear poly bushing kit # RM-4139-125 is indeed a fit for your 2011 Tiffin Allegro built on a Ford F-550 chassis. Roadmaster notes that some of the endlink parts may not be used in the installation and that the fit assumes a 1-1/2 inch OEM bar.
Your bar at 1-27/64 inches (1.42 inches) is very close but ultimately too small for a proper fit and you will need a different option.
The other option is # RM-4139-300 for a 1-3/8 inch diameter bar. This is actually closer to the 1.42 inch bar you have than kit # RM-4139-125 for 1-1/2 inch bars.
Product Page this Question was Asked From
Roadmaster Polyurethane Bushing Kit for 1-1/2" Diameter, Factory Rear Anti-Sway Bar
- Anti-Sway Bars
- Anti-Sway Bar Bushings
- Rear
- 1-1/2 Inch Diameter
- Roadmaster
more information >
Continue Researching
- Q&A: What Replacement Roadmaster Polyurethane Bushing Kit doI Need for My Itasca Suncruiser 32v V10?
- Q&A: Replacement Anti-Sway Bar Bushings for Motorhome On Ford F-53 Chassis
- Q&A: Replacement For Roadmaster B451 End Link
- Q&A: What is the Rear Sway Bar Size of a 2002 Ford F-53
- Q&A: Do the Roadmaster Replacement Bushings Need to be Pressed In for the Install?
- Q&A: What Replacement Converter Do I Need for a Series 7300 Model 7345 Converter?
- Q&A: Troubleshooting Trailer 12 Volt Accessory Circuit Not Active on Vehicle
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams