Installation Lift Recommendation for Curt Wiring Harness # 56016 on a Low Sitting 2011 Mazda CX-9
Published 09/21/2016 >
Products Featured in This Question
Question:
We dont have a lift to raise the car and work underneath it as you show in the video. It makes it a little tight to run the wire from the back to the battery in the engine compartment up front. Would you ask a local mechanic if you could pull in one of their work stalls? Or would you ask around to see if a neighbor might have on their garage that you could use if you drove over there? Or what would make it easier to work from the ground?
asked by: C P
Expert Reply:
I have a solution for you below, but you could go to a local garage and see what they say, more than likely they will not allow it because of liability reasons. The might offer to install it for you at a price.
We do offer car service ramps like the Race Ramps # RR-XT-2 or the more economical for occasional use the FloTool # FT11912MI.
Your 2011 Mazda CX-9 weighs up to 4,546lbs so you will want to keep this in mind while looking at ramps capacities. Both ramps will work for helping out with installing your Curt wiring harness # 56016 power wire routing.
I have linked all the above mentioned products as well as a few installation videos for you to check out.
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- No Tow Package
- 4 Flat
- Plug and Lead
- Plug-In
- Hidden
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement 12 Inch Wheel and Tire for a Harbor Freight/HaulMaster Trailer
- Q&A: How to Get Separate Turn Signals and Brake Lights to Work on a Trailer
- Q&A: Using Stabilizing Straps on a Cargo Hauler in the Curt Hitch on a 2012 Honda CR-V
- Q&A: J-Case Fuse Position For Curt 7-Way Harness On 2024 Honda Pilot Blocked
- Q&A: Wiring Installation Instructions for Hopkins LED-Compatible Tail Light Converter # HM48895
- Q&A: How to Test a 4-Way Trailer Wiring Harness Plug
- Article: Trailer Wiring Diagrams
- Q&A: What Should the Voltage Output Be at the 4-Way Plug on Curt T-Connector Wiring Harness # 56016
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What Exactly is Tongue Weight?
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Routing the Power Wire for a Trailer Wiring Harness



