What is the Wall Thickness of the DrawTite Combo Bar # 2852
Published 08/16/2016
Question:
What is the wall thickness of the receiver tubing?
asked by: Bob
1
Helpful Expert Reply:
The wall thickness of the Draw-Tite combo bar # 2852 can vary slightly from one to the next but it is approximately 3/16 of an inch. I have linked a video review of this bar for you.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Combo Bar with 2" Trailer Hitch Receiver - 24" Long - Unpainted
- Hitch Fabrication Parts
- Receiver Tube
- 24 Inch Long
- Raw Finish
- Fits 2 Inch Hitch
- 1/4 Inch Thick
- Draw-Tite
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Installation Time for Blue Ox BX1128 Flat Tow Base Plate Kit for 2016 Jeep Grand Cherokee
- Q&A: Replacement Trailer Taillight Lens Marked DOT P2PCA 99
- Q&A: Will the Bolt-On Shock Kits for Trailers Work With Underslung Axles
- Q&A: Recommended Mounting Bracket For Fulton F2 Jack
- Q&A: Replacement Arm For A Solera Edge 2000 Series RV Awning
- Q&A: How Much Time Should The Roadmaster Comfort Ride Suspension # RM-2460-2570 Take To Install?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Does SnapPad for 11-1/2" or 12" Round Jack Foot Come in a 2 Pack
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Tire Sizing
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Lighting Requirements
- Article: Trailer Maintenance Schedule
- Article: Where to Position the Trailer Axle?