What Size Hole Is Needed For Mounting Optronics Trailer Light, # MC57AB, In A Rubber Grommet
Updated 09/27/2010 | Published 09/26/2010 >
Products Featured in This Question
Question:
what size hole is to be drilled for miro-flex 4 s/t/t and 2 clearance lights? both will be mounted in rubber grommets.
asked by: J.R.M.
Expert Reply:
To mount the Optronics Trailer Light, # MC57AB, in a rubber grommet you would use the Optronics 2-1/2 Inch Round Grommet - Flush Mount, # A55GB. This grommet will require a 3 inch mounting hole.
To mount the Optronics Miro-Flex, Sealed, 4 Inch Round, Stop/Turn/Tail Light Trailer Light, # STL23CCRB, in a rubber grommet you would use the Optronics Rubber Grommet for 4 Inch Round Trailer Tail Lights, # A45GB. This will require a 4-1/2 inch mounting hole.
Product Page this Question was Asked From
Optronics Trailer Clearance or Side Marker Light - Submersible - Incandescent - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- Incandescent Light
- 2-1/2 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Side Marker Light Similar To Glo Brite Red 410
- Q&A: Replacement Bearing Kit for a # 42 Spindle on a 8,000 lbs Axle
- Q&A: Wiring the Control Adapter Module for HydraStar Electric-Hydraulic Brake Actuators # HBA-CAM
- Q&A: Replacement Spring-Loaded Plunger Pin for Bulldog Electric Landing Gear # BD500170
- Q&A: What is Difference Between Fulton F2 Trailer Jacks F1413040134 and F1413140334
- Q&A: Best 7-Way Wiring Harness For 2017 Honda Pilot
- Q&A: What Wheel Covers Will Stay on a 15" 5-Lug Horse Trailer?
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Trailer Wiring Diagrams
- Article: How to Raise Your Travel Trailer Height
- Article: How Level Should a Tow Bar Be When Flat Towing

