Recommended Transportation of Motorcycle and Boat Trailer with a 2003 Ford F-350 Long Bed Diesel
Published 07/06/2016 >
Products Featured in This Question
Question:
Hi, I have a ford f350 long bed diesel. I am researching a hitch carrier for motorcycle. I will use the bike to shuttle for fishing trips so I have to pull a boat/trailer. I live near Jackson Hole, WY and travel through wyoming, utah, nebraska, montana, and idaho. I didnt see a carrier for the rear of the truck with a receiver for the boat/trailer. Not sure how the front carrier mounts. Thanks for any help,
asked by: Dean J
Expert Reply:
I do have a solution for you, but there aren't any motorcycle carriers that also are capable of towing a trailer.
The best solution is for you to transport your motorcycle in the bed of your truck with some ratchet straps like # EM05710 and to help load it with a ramp like # EM07464. Then tow your boat trailer with a ball mount and ball. To determine the correct ball mount needed for your trailer you will need to take a few quick measurements. I have linked a Help Article on how to do this for you to check out. The correct ball mount and ball will also depending on your receiver size and boat trailer coupler size. For example, if you have a 2 inch hitch and need a 2 inch drop for a 2 inch coupler with a trailer weight of 5,000lbs; a ball mount and ball that would be good for you is the # C45036. If you instead have a 2-1/2 inch hitch you would want the # C45456 with the # A-90 ball.
I have linked all the above mentioned products as well as a few helpful links to this page for your convenience.
Product Page this Question was Asked From
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Visible Cross Tube
- 500 lbs Vert Load
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media




Continue Researching
- Q&A: Recommended Front Hitch for a 2025 Chevy Silverado 2500 w/ the Most Clearance Past the Hitch Pin
- Q&A: Can I Swap My Reese Sidewinder for the MORryde GooseTech 5th Wheel to Gooseneck Pin Box?
- Q&A: Front Mount Trailer Hitch Receiver For 2001 Ford F-350 Without Having To Remove Front Bumper
- Q&A: Comparison Between Draw-Tite # 65022 and Curt # 31114 Front Mount Receivers for 1999 Ford F250
- Q&A: Front Mount Hitch Fit for a 2005 Ford F-350 Super Duty
- Q&A: Where Are Draw-Tite Hitches Made?
- Q&A: Does the Dry Mode On My Furrion Air Conditioner Help with Cooling My RV in Humid Conditions?
- Article: Stability Control for Heavy Duty Vehicles
- Article: Trailer Wiring Diagrams
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Wire an Electric Winch
- Article: How to Choose the Right Trailer Hitch Class
- Article: My Trailer Hitch Doesn't Fit

