How to Determine if 2013 Jeep Wrangler has Factory Tow Package and Adding 7-Way and Brake Controller

Updated 04/22/2016 | Published 04/20/2016

Products Featured in This Question

Universal Installation Kit for Trailer Brake Controller - 7-Way RV and 4-Way Flat - 10 Gauge Wires

(3480)

$118.67

Question:

How can I tell if my 2013 Jeep Wrangler has a factory tow package? It has a flat 4 wire connector, but I dont know if this aftermarket. I purchased the Jeep used.

asked by: Fred Y

Expert Reply:

The easiest way to determine if your 2013 Jeep Wrangler has the factory tow package is to have a dealer run the VIN. They should be able to tell you how the Jeep was equipped using the VIN. But if the Jeep came with a 4-Way and not a 7-Way then it is probably not the factory tow package which I do believe came with a 7-Way connector.

To add a 7-Way to models that did not come with a factory 7-Way you would use # ETBC7. Your 4-Way will plug into this adapter and provide both a 4- and 7-Way connector. Then the remaining wires will get hardwired to the vehicle and a brake controller to make them fully functional.

For a brake controller I recommend the P2 # 90885 because it is easy to set up and use and it is reliable. I have included some links that show and explain the ETBC7 installation for you.

expert reply by: Michael H