Replacement Hardware for Curt Class III Trailer Hitch 13085 for 2002 Ford Windstar
Updated 04/21/2016 | Published 04/19/2016
Products Featured in This Question
Question:
I need six bolts and 6 plates for this hitch. Do you sell these hardware only for Curt # 13085?
asked by: Jimmy C
Expert Reply:
We do indeed sell the hardware kit for the Curt # 13085 hitch for a 2002 Ford Windstar. You'd want to order our replacement hardware kit, part # RHK. On the product page, there's a field where you can input the hitch part number, 13085 and a drop down menu where you can choose the hitch manufacturer, which is Curt.
The kit contains the following:
1 Fishwire tool for 1/2 inch bolt
6 1/4 inch x 1 inch x 2-1/2 inch square hole spacer plates
6 1/2-13 x 1-3/4 Carriage bolts
6 Hex Flange Nuts for 1/2 inch bolts
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Q&A: Overall Length of the Replacement Gear Motor Assembly for Power Gear Slide-Out 368200
- Q&A: Replacement LED Top Command Clearance Light With SAE-AP2-16 On Lens For 2018 Sunseeker Motorhome
- Q&A: Recommended Hitch for a 2024 Mazda CX-50
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Trailer Brakes are Very Weak Even After Adjusting Them
- Q&A: What is the Hole Spacing for Curt Trailer Hitch 13085 for a 2001 Ford Windstar