What Size are the Bolts to Install Draw-Tite Trailer Hitch 75128 on a 2003 Jeep Liberty
Updated 03/04/2016 | Published 03/03/2016
Products Featured in This Question
Question:
jeep liberty 2003 what size bolts are needed for trailer hitch
asked by: c F
0
Expert Reply:
Draw-Tite trailer hitch # 75128 for your 2003 Jeep Liberty uses M12 (12mm) bolts that thread into the matching M12 weldnuts inside the frame of the vehicle. The hardware comes with the hitch but if you need replacement hardware for the hitch use # RHK. Just enter the hitch number and manufacturer where indicated on the RHK page to get the correct hardware. I have included a link to a video showing an example installation for you.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 7500 lbs WD GTW
- 2 Inch Hitch
- 750 lbs WD TW
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Size of Install Bolts Used for Hitch on a 2007 Jeep Liberty
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Q&A: Where Will Curt C31022 Front Mounted Hitch Sit When Installed on 2005 Jeep Liberty
- Q&A: Best 2 Kayak Carrier for a 2005 Jeep Liberty Renegade
- Q&A: What Size Wrench is Used to Tighten Curt 2 Inch Trailer Hitch Ball 40038
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector