Installation Instructions for Halogen Docking Light Kit, # DL-16CC.
Updated 11/01/2024 | Published 07/26/2010 >
Question:
need wiring diagram for these lights
asked by: Fabian
Expert Reply:
I can certainly provide you some installation instructions for the Halogen Docking Light Kit, # DL-16CC.
First, drill a hole at the desired mounting locations, slip on the rubber boot cover, then install the lights using the included hardware. Disconnect the battery to avoid short circuits/electrical shock. Measure the wire needed to install the lights on your boat and cut the red wire into the lengths needed. Place the plastic terminal covers onto the wire and attach the corresponding metal terminals.
Mount the switch in a convenient location. Then, snap the wiring together. Reconnect the battery. Finally, loosen the bolt on the side of each light, adjust the beam to the desired level, and re-tighten securely.
Product Page this Question was Asked From
Halogen Docking Light Kit - 35 Watt - Lighted Switch and Safety-Fused Wiring - Black Housing
- Boat Lights
- Docking Lights
- Deck
- Black Housing
- Surface Mount
- Halogen Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Why Does a Marker or Clearance Light Only Have One Wire
- Q&A: Which Pin On A 7-Way Should Have Constant 12V Power When Vehicle Is Running
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Is There a Support Brace Designed for the Replacement Crank Extension for Lippert Spare Tire Winch?
- Q&A: Recommended 4" x 6" Utility Work Light
- Q&A: Does the Macerating Seaflo Fresh Water Electric RV Toilet Fit a Standard Toilet Flange?
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Trailer Lighting Requirements


Brian
11/1/2024
Do you have a decent picture and clear explanation