Brake Controller Install Harness Recommendation for 2016 Toyota Tundra 4.6L V8
Published 02/14/2016
Question:
The 2016 4.6L V8 comes only with the hitch and not the intreated brake controler.Is it prewired to install a brake controller? plug in with adapter Thanks,
asked by: H.Tookes
Helpful Expert Reply:
Yes, your 2016 Toyota Tundra that has a factory 7-way installed at the rear of it is pre-wired for a brake controller. To install our best selling P2 brake controller part # 90885 all you would need is the install harness part # 3031-P which has been confirmed as a fit for your truck.
To see where the harness is located check out the install instructions link I attached. You will need to remove the panel to the right of your steering wheel to access it.
Continue Researching
- Shop: Brake Controller
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Best Bike Racks for Electric Bikes
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Dexter Brake Assembly Recommendations to Replace Part Number 023-357-00