Replacement LED Utility Light for the Outside of a Travel Trailer
Updated 02/09/2016 | Published 02/07/2016
Question:
Hello, I was getting ready to place an order and was hoping you could help. I have two factory spot lights on the outside of my camper. One on each side. I have a sent a picture of one of the lights. It has a number of 30504 on the lens. They appear to be the same size lights by measurement, screw holes and would fit inside the chrome trim. I was wondering if you think they would fit correctly and would be a little brighter then what I have now?
asked by: Kyle L
Expert Reply:
Transit LED backup light # BUL90CB would definitely be bright since it uses 42 diodes. Take a look at the video I have linked to get an idea of the brightness.
But to determine if it will fit in place of the lights you have now you would need to go by the mounting hole measurements. The light mounting holes are 6-1/4 inches apart on center. If that is what you have then this LED light is a good option.
Product Page this Question was Asked From
Optronics LED Backup Light for Transit Vehicles - Submersible - 42 Diodes - Round - Clear Lens - 12V
- Trailer Lights
- Tail Lights
- Backup
- Round
- Surface Mount
- Submersible Lights
- LED Light
- 7 Inch Diameter
- White
- Optronics
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Article: Trailer Wiring Diagrams
- Q&A: Are Bearings L44549 and L44649 Interchangeable
- Q&A: What Is The Smallest Wheel Size Compatible With 3500lb Axle Hub and Drum Assemblies?
- Q&A: Recommended Hub Assembly for a Trailer w/ L44549 Bearings
- Q&A: Replacement Hub for Triton Snowmobile Trailer
- Q&A: Adding Electric Drum Brakes to a Scamp Camper Trailer
- Q&A: 20.5x8-10 Trailer Tire Diameter