Replacement 5th Wheel Trailer Landing Gear Brackets
Updated 01/18/2016 | Published 01/17/2016
Products Featured in This Question
Question:
I dont know what type of landing gear Im working with, is there any dimensions on these brackets? Height, width, depth, thickness ? from what the picture shows it looks like its made of galvanized steel, that wouldnt be good for welding. is it made of galvanized steel?
asked by: Chris T
Helpful Expert Reply:
The Lippert landing gear bracket # LC113511 is 2" long x 3-1/2" wide x 4-1/2" tall just like # LG-Brackets. They are roughly 3/16 inches thick but that can vary some so a range of 1/8 to 3/16 inches would cover it. For the most part landing gear is all dimensionally the same which is why many of the parts are interchangeable amongst the different brands. You could go with either of the above part numbers and they would work.
Both are also raw steel, not galvanized, and are meant to be welded on. As you probably know, galvanized steel can be welded but it gives off toxic fumes and requires a skilled welder with galvanized welding experience. So that is why they make them from raw steel.
Product Page this Question was Asked From
Replacement Weld-On 5th Wheel Landing Gear Leg Bracket for Lippert RVs
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Mounting Hardware
- Brackets
- Lippert
more information >
Continue Researching
- Q&A: How To Install the Landing Gear Set Part # RVLG-8000
- Q&A: Replacement Follow Landing Gear Leg for 1998 Fleetwood Savanna 5th Wheel
- Q&A: Solution for Needing Kwikee Best Replacement Jack 359278
- Q&A: Tire and Wheel Size to Replace 18.5x8.5-8 on Trailer
- Q&A: How Can I Replace Lippert Unity X1 Control Board Part 801171
- Q&A: Towing a 5th Fifth Wheel Trailer with a 2017 Nissan Titan XD 6 1/2 Bed
- Q&A: Will Buyers Products King Pin Work with Superglide Fifth Wheel Hitch