Trailer Hitch and Wiring Harness Recommendation for 2015 Kia Sedona

Published 12/22/2015

Products Featured in This Question

2" Hitch Ball - 1" Diameter x 2-1/4" Long Shank - Chrome - 12,000 lbs

(3881)

$19.94

Powerbuilt Dual Drive Torque Wrench - 3/8" and 1/2" - 10 to 150 ft-lb

(52)

$56.95

Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"

(164)

$231.90

Pin and Clip for 2" and 2-1/2" Hitches - 5/8" Diameter x 3-3/16" Span

(2939)

$4.58

2-5/16" Hitch Ball - 1" Diameter x 2-1/4" Long Shank - Chrome - 10,000 lbs

(3881)

$25.41

Curt Dual Length Ball Mount for 2" Hitches - 2-3/8" Rise, 3-5/8" Drop - 7,500 lbs

(164)

$55.17

Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector

(258)

$86.74

etrailer Trailer Hitch Receiver Lock for 1-1/4" Hitches - Flush - 2-1/8" Span - Chrome

(3606)

$33.97

Question:

would like to know what type of harness do i need to use on a 2015 KIA sedona. Im gathering information of parts needed to install a new hitch on our new van. thank you.

asked by: Marcos

Helpful Expert Reply:

We offer a replacement 4-pole flat trailer wiring harness for the 2015 Kia Sedona that has the factory tow package connectors. Curt harness # C56256 plugs in behind the underbody panel on the rear driver's-side corner as shown in the linked video. You will make two plug-in connections at this OEM wiring, install the supplied 10-amp fuse and mount the converter box using the included double-sided tape. This 4-pole trailer connector will then provide stop, turn and taillight signals to your trailer.

For a hitch I suggest the Curt # C13115 because it has the same 400-lb tongue weight capacity as the other hitches but costs less. An installation video for this hitch is linked for you along with the instructions and a helpful article with hitch installation tips. The required mounting hardware is included. You'll need mostly basic hand tools but a torque wrench like # ALL944001 will also be required to tighten all of the fasteners to the values shown in the instructions. The hitch installs without any drilling.

Towing will also require a ball mount with the correct amount of height rise or drop to keep your trailer level when hitched to your Sedona. The recommended ball mount for your car is part # C45230 but if you need a different amount of rise or drop just refer to the linked article for guidance in selecting a ball mount.

For a hitch ball use either 1-7/8-inch ball # C40051, 2-inch ball # 40038 or 2-5/16-inch ball # C40007. For a pin and clip to secure the ball mount use part # C21500, or if you want to be able to lock the ball mount to your hitch, part # e98879.

You'll also want to check your owner's manual to confirm the car's towing capacity before you pull any trailer.