Length of Lippert Electric Stabilizer RV Jack Support Arm # 142433
Published 11/05/2015
Question:
How long does this measure? I just want to make sure it is the same part. Just wondering the dimensions. Thanks
asked by: Veronica L
1
Helpful Expert Reply:
In total, the Lippert Electric Stabilizer RV Jack Support Arm, part # LC1134122 is 19.3 inches in length. Center hole to center hole distance is 17.8 inches. I've shown these dimensions on a photo I've edited for you.
expert reply by:
Mike L
1
click to enlarge
Product Page this Question was Asked From
Replacement Electric Stabilizer Jack Support Arm for Lippert RV Jack - Yellow - Qty 1
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Stabilizers
- Lippert
more information >
Continue Researching
- Q&A: Is There A Replacement Leg For Lippert Electric Stabilizer Jacks PSX1?
- Q&A: What Replacement Jack do I Need for My Lippert Level Up with Part Number 343315-RA?
- Q&A: Does Lippert Schwintek Slide-Out System Column Height Include the Motor Height?
- Q&A: Correct Replacement Arm for Lippert Components PSX1 High-Speed Power Stabilizer Jacks
- Q&A: Replacement Stabilizer Jack Support Arm for a Lippert Electric Stabilizer Jack
- Q&A: Lippert Hydraulic Level Up Generation II Jacks For Towable RV Campers
- Q&A: Replacement for Atwood Air Command AC
- Article: How to Mount a Truck Bed Camper
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: How to Raise Your Travel Trailer Height
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)