How Would the Custer Single Function LED Strobe Driver # STR-QRLY Wire to a Switch

Updated 08/10/2015 | Published 08/09/2015

Products Featured in This Question

Custer Single Function LED Strobe Driver - Quad Flash

(2)

$15.73

Derale Lighted On/Off Switch for Electric Fans

(4)

$6.15

Question:

I see there are 4 wires on the relay. I want to use the relay for my turn signals on a Polaris RZR. I want to wire it thru a fuse, non switched on power in then thru a switch to each left, right led, think I can do this or will I need a relay for left and one for right? Thanks

asked by: John

Expert Reply:

You would need a Custer Single Function LED Strobe Driver # STR-QRLY for each light circuit that you want to strobe. On the in side of the unit you would want to run your switch like part # D16740 on either the power or ground side.

Then on the output side you would just run that to the lights you want to strobe.

You should note that this strobe unit is not designed for use as a blinker system.

expert reply by: Jameson C