Trailer Hitch and Wiring for a 2008 Chrysler Sebring Convertible with Dual Exhaust
Updated 08/04/2015 | Published 08/03/2015
Products Featured in This Question
Question:
Draw-Tite trailer hitch for 2008 convertable with dual exhaust is this the Draw-Tite for a 3.5 L engine to pull a rental trauler?
asked by: Cynthia K
Expert Reply:
Draw-Tite trailer hitch # 24871 will fit your 2008 Chrysler Sebring convertible with dual exhaust. It can be used to tow a rental trailer. The hitch has a 2,000 pound gross trailer weight capacity but check the vehicle owners manual to the Sebring's capacity and go by whichever is lower.
You will need the proper ball mount, part # 3594. To add a 1-7/8 inch ball use # 19256 and for a 2 inch ball use # 19258. And for trailer wiring you can use # 118444 to add a 4-Way flat connector. I have included links to videos showing the hitch and wiring being installed.
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Search Results: trailer hitch
- Video: Detailed Breakdown of the Optronics Wishbone 4-Way Trailer Wiring Harness
- Video: Review of Hopkins Custom Fit Vehicle Wiring - Vehicle Wiring Harness 4 Pole Flat - HM11142265
- Video: How to Install the Draw-Tite Sportframe Trailer Hitch Receiver on a 2008 Chrysler Sebring
- Shop: Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Shop: 25 ft. Wishbone 4-Way Trailer Wiring Harness with 42" Ground Wire
- Q&A: Availability of Trailer Hitch Receiver for Towing with 2008 Chrysler Sebring Hard-Top Convertible
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: How Tight Should the Spindle Nut be on a Dexter 8,000 Pound Axle
- Q&A: Replacement 4.4K Electric Brakes with Offset Mounting Bolt Pattern
- Article: How to Measure for Trailer Hitch Drop
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Q&A: How to Figure Out Which Reese Goose Box Fits Fifth Wheel Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Identifying Industry Standard Above-Bed Rails (ISR) on 2011 Chevrolet Silverado
- Q&A: Is There a Class II Trailer Hitch Receiver Available for a 2008 Chrysler Sebring Convertible