Wiring the Switch for the Halogen Docking Light Kit
Published 08/01/2015
Question:
do I split the black wires from the switch to the neg terminal?
asked by: Moses
0
Expert Reply:
Since the switch only has the 3 terminals, ground, power in, power out, only the power out would be split to the 2 different lights in kit # DL-16CC. There only needs to be one ground (negative) at the negative battery terminal and there is just the one 12 volt power source coming from the positive battery terminal.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Halogen Docking Light Kit - 35 Watt - Lighted Switch and Safety-Fused Wiring - Black Housing
- Boat Lights
- Docking Lights
- Deck
- Black Housing
- Surface Mount
- Halogen Light
- White
- Optronics
more information >
Continue Researching
- Q&A: Will The Curt Trailer Hitch Receiver C82RJ Fit The 2027 Kia Telluride
- Q&A: Replacement LED Flood Light for Load Lights on a Horse Trailer
- Q&A: Is There a Support Brace Designed for the Replacement Crank Extension for Lippert Spare Tire Winch?
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Does the Macerating Seaflo Fresh Water Electric RV Toilet Fit a Standard Toilet Flange?
- Q&A: Recommended 4" x 6" Utility Work Light
- Q&A: How To Install the ThinLine LED Light As An Identification Light On Trailer Over 80 Wide
- Q&A: Replacement for Oil Cap 21-88 for 9K, 10K, and 12K Oil Bath Trailer Axle Hubs
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Article: Trailer Lighting Requirements