Measurements for Lippert Solera Power Awning Bezel Spacer
Updated 07/31/2015 | Published 07/30/2015 >
Question:
Please post the measurement for this switch spacer. Inside hole, screw holes on center, front area lip to lip right to left and over all size, H x W x D.
asked by: Jeff
Expert Reply:
I spoke with Lippert about the measurements on the Power Awning Bezel Spacer # LC285079. They told me that the overall dimensions are 3-1/2 inches tall x 3 inches wide x slightly larger than 5/8 inch (0.63 inch). The inside diameter is 1-1/2 x 1-1/2 inches. From center to center between the screw holes is approximately 2-3/32 inches (2.09 inches).
I have attached a diagram showing these measurements for you.
Product Page this Question was Asked From
Replacement Power Switch Bezel for Solera Power RV Awnings - White
- Accessories and Parts
- RV Awning
- Switches
- Solera Replacement
- White
- Lippert
more information >
Continue Researching
- Q&A: Recommended Replacement AC System for a GE ARH15AACBL2 AC Unit
- Q&A: Will The Victron SmartShunt Battery Monitor Work With Lead Acid And Lithium Batteries?
- Q&A: Is Pre-Charge Resistor Needed When Installing Rich Solar NOVA 3k12
- Q&A: Dimmer Switch for LED Lights in Trailer
- Q&A: Is the Optronics Flexible LED Light Strip Dimmable
- Q&A: Does Etrailer Do Lithium Battery System Upgrades on Trailers?
- Q&A: Recommended Replacement For A Ventline Elixir Roof Vent Fan With Light


