Fifth Wheel Wiring for a 2008 Toyota Tundra
Updated 05/04/2020 | Published 05/06/2008
Question:
I have a 2008 Toyota Tundra with the factory trailer plug. I am looking for a wiring kit to put a 7 pin receptacle in the bed for a fifth wheel camper. I am wanting something that I would not have to cut into my factory wiring.
asked by: Bruce
0
Expert Reply:
To install the 7-way connector into the bed of your 2008 Toyota Tundra, we offer the Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness with 7-Pole Plug # HM43397.
This harness will plug into the existing wiring, with no cutting or splicing required.
expert reply by:
Sarah
0
Product Page this Question was Asked From
Hopkins Endurance 5th Wheel/Gooseneck 90-Degree Wiring Harness with 7-Pole Plug
- Custom Fit Vehicle Wiring
- 5th Wheel and Gooseneck Wiring
- Vehicle End Connector
- No Tow Package
- 7 Blade
- Plug and Lead
- Plug-In
- Hopkins
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Does Landing Gear Leg LC179013 Attach Directly to Motor
- Q&A: Need Replacement Axle for LCI 4400 LB axle that says 95.5/75
- Q&A: Replacement Refrigerator Recommendation for a Norcold Model N 300
- Q&A: Correct Way to Wire Trailer Breakaway Kit
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Q&A: Recommended Leaf Spring Enhancement For A 2019 Ford F-450 Cab & Chassis
- Q&A: Installing a Brake Controller on a 2003 Ford F-150 Without a Factory Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
John
5/1/2020
Where does the cord clip into the existing system?? Under the Dash? Back at he factory 7 pin connector next to the Ball receiver?? Do you have a video showing this installation??