Location Of Port On 2012 Cadillac SRX With Factory Tow Package To Install T-One Wiring Harness
Updated 05/07/2015 | Published 05/06/2015
Products Featured in This Question
Question:
I have a 2012 SRX. Where do I plug this connector?
asked by: Ken
Expert Reply:
The port that you plug the T-One Vehicle Wiring Harness, part # 118259 into is located behind the rear bumper above the place a hitch would be installed. This harness is designed for vehicles that have a factory tow package.
I have attached a link to an installation video for this harness on a 2012 SRX you can check out. At the 10 second mark on the video it shows where you can find the port you need to connect the harness.
If you do not have the factory tow package, you will need to hardwire a harness like part # C59236. I have attached a link to an installation video for this harness.
When working with electrical connectors I recommend using dielectric grease like part # 11755. This keeps dirt and moisture out of the electrical connections and helps prevent corrosion.
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Shop: Trailer Wiring
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: Trailer Wiring Harness Installation - 2012 Cadillac SRX 56096
- Video: All About the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector-56096
- Search Results: 4 pin flat to 4 pin round adapter
- Search Results: 814092
- Q&A: What Weight Capacity of Tongue Jack is Needed for a 4,600 Pound Dry Weight Trailer
- Q&A: How to Choose the Correct Replacement Trailer Jack With Enough Ground Clearance on Rough Terrain
- Q&A: Is Trailer Jack Capacity for Tongue Weight or Trailer Weight