Troubleshooting Vibration/Buzz at Idle After Trailer Hitch Install
Updated 02/23/2015 | Published 02/22/2015
Question:
I installed one of these on my 2008 Outlander LS a couple years ago. Ever since, there has been an annoying vibration/buzz at idle. Everything is tightened down, no other problems. Is there something structurally that it comes in contact with that may cause this? Otherwise, no issues. Thanks!
asked by: Dennis K
Expert Reply:
It sounds like your exhaust may be rattling against the hitch when at idle. This is a fairly common problem that can be fixed pretty easily. Basically you will have to reposition the exhaust so that it is further away from the hitch and will no longer contact it at idle.
I attached a help article and video for you to check out that will detail how to fix the problem.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 400 lbs TW
- 4000 lbs GTW
- 2 Inch Hitch
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Parts Needed To Install A Brake Controller In A 2012 Toyota Sienna LE
- Q&A: Thule Apex XT4 VS Yakima Ridgeback 4 On A 2017 Toyota Highlander
- Q&A: Recommended 7-Way Connector for a 2024 Subaru Forester w/ a 4-Way Connector
- Article: Determining Trailer Tongue Weight
- Q&A: How To Install 5-Way Trailer Connector On 2015 Jeep Wrangler Unlimited
- Q&A: How to Add 5-Way Trailer Connector on 2016 Jeep Wrangler
- Q&A: Similar Tire Size Replacement for 7.50x16 That Is Radial Construction
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Air Bag Helper Springs for a 2012 Mitsubishi Outlander
- Article: Trailer Hitch Installation Tips