New Arrivals

Restore your Curt TruTrack 2P hitch with this direct replacement head. Built to fit 5,000-lb to 8,000-lb systems only (17599), it keeps your setup towing straight with integrated sway control right where you need it.

• Accessories and Parts
• Weight Distribution Hitch
• Head
• CURT

For heavy-duty applications that require cable, this steel winch cable has a break strength of 4,200 lbs and a working load limit of 1,400 lbs.

• Accessories and Parts
• Electric Winch
• Trailer Winch
• Cables and Straps
• 3/16 Inch Diameter
• 4200 lbs
• Wire Rope
• CURT

Install your Curt electric trailer brake controller quickly and easily with this custom wiring adapter. Simply plug one end of the adapter into your brake controller and then plug the other end into the built-in port beneath your vehicle's dash.

• Accessories and Parts
• Trailer Brake Controller
• Wiring Adapter
• Plugs into Brake Controller
• Vehicle Specific
• CURT

Replace the lost or damaged center pin for your Curt PowerRide fifth-wheel trailer hitch. Pin secures the 5th wheel head to the hitch body.

• Accessories and Parts
• 5th Wheel Hitch
• Pins and Clips
• CURT

Replaces the short bed bracket for your Curt OEM puck system gooseneck ball kit (C60668 or C60663). Compatible with 2023-2025 GMC Sierra and Chevrolet Silverado trucks with 6.5' short beds.

• Accessories and Parts
• Trailer Hitch Ball
• Mounting Hardware
• Brackets
• CURT

Replaces the extension plates for your Chock-N-Lock wheel stabilizers (71001-BX). Expands your wheel chock to stabilize your trailer when parked. Includes one pair of plates.

• Accessories and Parts
• Camper Jacks
• Wheel Chocks
• Extension Plate
• InfiniteRule

Heavy-duty, stainless steel locks provide superior security when locking your B&W hitch step to your B&W Tow and Stow 2" or 2-1/2" ball mount. Third-party-tested pin has a 42,000-lb shear strength.

• Accessories and Parts
• Hitch Step
• Pins and Clips
• InfiniteRule

All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.

• Accessories and Parts
• Trailer Brakes
• Electric Drum Brakes
• RH
• 5200 - 7000 lbs
• Brake Assembly
• 12 x 2 Inch Drum
• Lippert

Replaces the 3/8" x 2-1/8" pin for your Lippert Solera RV awning. Dacromet finish provides corrosion resistance.

• Accessories and Parts
• RV Awnings
• Hardware
• Pins
• Lippert

Replace a cracked or faded switch bezel on your Power Gear leveling system with this black/silver trim piece. Snaps in easily for a quick cosmetic fix. Works on select Power Gear RV leveling system control panels.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Controllers
• Control Panel
• Bezel
• Lippert

Replace your RV's old or damaged awning roller and fabric with this heavy-duty assembly. Fits Edge and 2000 series 8' power awnings with a built-in LED strip. Installs more easily than replacing just the fabric.

• Accessories and Parts
• RV Awnings
• Fabric
• 8 Feet Wide
• Extends 7 Feet
• Black Fade
• Lippert

Restore push-button power to your Solera awning with this replacement arm kit featuring matching 69 inch Regal arms, flat-back mounts, top-routed wiring, and a black 12-volt rocker switch - just swap the arms and keep your current fabric and roller.

• Accessories and Parts
• RV Awnings
• Arms
• 69 Inch Long
• Pitch Arms
• Flat Awnings
• Black
• Lippert

Replaces the auto-leveling control box for your Lippert Power Gear hydraulic RV leveling system.

• Accessories and Parts
• Trailer Jack
• Control Panel
• Lippert

A damaged harness can make your RV's leveling system unreliable. This 25' replacement restores electrical connections, helping your jacks work smoothly. Designed for Lippert Level-Up systems, it's a simple fix to get you back to camping.

• Accessories and Parts
• Camper Jacks
• Trailer Jack
• Wiring Harness
• Lippert

Restore your Solera Edge slide-out awning with this full idler side replacement kit. Designed for all Solera Edge toppers, it includes black-finished hardware and wire support components for a secure, like-new installation.

• Accessories and Parts
• RV Awning
• Hardware
• Lippert

Replaces the electric steps, motor, and control unit for your Kwikee 47 Series RV step. Motor and control unit automatically extend and retract the steps when you open and close the door. Wiring pigtail hardwires to your RV's power.

• Accessories and Parts
• RV Steps
• Motors
• Control Module
• Steps
• Lippert

This kit includes the hardware for your Solera 2000 Series or Edge awning. The needed awning roller tubes and fabrics are sold separately. The 58" long arms offer sliding adjustable pitch. The wire is located at the bottom.

• Accessories and Parts
• RV Awnings
• Arms
• Pitch Arms
• Lippert

Replaces the front cover of the drive head on your Lippert Edge RV awning.

• Accessories and Parts
• RV Awnings
• Head Parts
• Head Cover
• Drive Head
• White
• Lippert

All it takes is one worn brake to throw your trailer off. Replacing a single ABS brake assembly restores smoother stopping and steadier tracking, so you stay in control on steep grades, in crosswinds, and during sudden traffic stops.

• Accessories and Parts
• Trailer Brakes
• Electric Drum Brakes
• RH
• 3500 lbs
• Brake Assembly
• 10 x 2-1/4 Inch Drum
• Lippert

Need an air distribution box for your ductless Furrion Chill Cube RV AC setup? This low-profile unit includes a remote control that can sense and adjust the temperature of the area in your RV that the remote is in.

• Accessories and Parts
• RV Air Conditioners
• Air Distribution Box
• White
• Furrion

Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.

• Accessories and Parts
• Brake Actuator
• Hydraulic Drum Brakes
• Disc Brakes
• 4 Feet Long
• Brake Lines
• Brake Line Components
• Kodiak

Replace the spacer on your Kodiak K71-2R-11-10D-DDDD disc brake kit. Designed for 11" rotors with an 8 on 6-1/2" bolt pattern and 5/8" studs, it restores fit and function for your 10,000-lb axle, keeping disc brakes working smoothly.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• 10000 lbs
• Rotors
• Rotor Spacers
• Kodiak

Worn brake hoses reduce stopping power. This DOT-approved Kodiak hose seals tight for leak-proof braking and resists rust for long-lasting performance. Dead swivel ends prevent twisting during installation. Works with any 3/16" brake lines.

• Accessories and Parts
• Brake Actuator
• Hydraulic Drum Brakes
• Disc Brakes
• 26 Feet Long
• Brake Lines
• Brake Line Components
• Kodiak

Caliper-mounting bracket is designed for use with 11.6" hub-and-rotor assemblies that have an 8 on 6-1/2 bolt pattern and 5/8" wheel bolts. Works with dually applications and mounts on 7-bolt, 10,000-lb Dexter brake flanges.

• Accessories and Parts
• Trailer Brakes
• Disc Brakes
• 10000 lbs
• Hardware
• Caliper Parts
• Mounting Brackets
• Kodiak