2021 Forest River Rockwood Roo Travel Trailer RV Jack Pads

Based on the information I could find you are going to need the SnapPad EQ Compact Jack Pads #SP24FR4. I have included an image you can use to verify your feet do look the same to fit these pads.

SnapPads like the SnapPad XTRA Jack Pads for Lippert Leveling Systems w/ 9" Round Jack Feet - Qty 6 Item #SP54FR6 can be taken off and on as needed so you won't have to keep replacing them every time you need to take…

I went out to our warehouse and test fit some SnapPads on the feet of the Lippert High-Speed Power Stabilizer Jack #LC298707 and found that the 6" square SnapPads were a fit. If your 2022 Forest River Vibe travel trailer only has…

Hey Tim, thanks for reaching out! The Stromberg Carlson Base Pad Extreme for RVs and Trailers #SC33VR have a 6,000 lb rating for each Base Pad Extreme so you're looking at a total of 36,000 lbs for this kit of 6. Ideally your jacks…

Hey Dan, The ground for the Roadmaster Brake-Lite Relay Kit for Towed Vehicles #RM-88400 typically gets tied into the ground for the braking system to intertwine them so that they're active at the same time. When used to prevent turn…

Personally I prefer the SnapPad XTRA Jack Pads #SP54FR4 over the Stromberg Carlson #SC99MR as they have been around much longer and proven themselves to be a quality product. Both these will fit 4 jacks with a 9" round landing pad.

The replacement Foot Pad for Lippert Hydraulic Ground Control Leveling System - Qty 1 #LC324269 needs to be torqued to 132 ft-lb and Lippert recommends using some Loctite Threadlocker 262 - High Strength - Up to 3/4" Nuts/Bolts -…

The Clearsource Ultra RV Water Filter System w/ VirusGuard #CS87FR weighs 34.125 lbs.

The SnapPad Prime Jack Pads #SP84FR4 are specifically designed to fit the Power Gear Leveling Systems w/ 10" Round Concave Jack Feet on your 2014 Fleetwood Bounder 34B. The Pads #SC99MR Stromberg told you to use will not fit on your…

Hey Joe, yes the Lippert stabilizer jack part #LC298707 does fit your Grand Design Transcend 245RL but it is sold individually so if you wanted a set for the front and the rear you would need to order a quantity of two.

You shouldn't really have any play with the Easy Grease Trailer Hub and Drum Assembly #AKHD-655-6-EZ-K. If you are getting play in it then the bearings most likely are either not set correctly or were the incorrect choice for your…

There's unfortunately not a guide to tell us the sizing of your trailer's jack pads so you'll want to measure and note the shape of each pad. I've run into numerous situations where the front and rear…