Trailer Hitch Size:
2-1/2 Inch Hitch Opening
Towing Capacity:
2500 Pound Tongue Weight
20000 Pound Towing
Weight Distribution Towing Capacity:
3000 Pound Tongue Weight
30000 Pound Towing
Trailer Wiring:
Features:
...pins and clips included - hitch locks sold separately Custom fit for your vehicle Made in the USA Specs: Top receiver opening: 2-1/2" x 2-1/2" 2" x 2" Adapter sle...
Installation Notes:
No drilling required for installation
Hitch installation can be made easier by loosening the spare tire, allowing it to be moved as needed
Factory hitch must be permanently removed for hitch installation
More Information >Trailer Hitch Size:
2-1/2 Inch Hitch Opening
Towing Capacity:
2700 Pound Tongue Weight
20000 Pound Towing
Weight Distribution Towing Capacity:
2700 Pound Tongue Weight
20000 Pound Towing
Trailer Wiring:
2017 Ford F-350 Super Duty Trailer Wiring
With tow package use C58044 for wiring
Features:
...mount, pin and clip sold separately Hitch assembled in the USA Mounting hardware may be imported Specs: Receiver opening: 2-1/2" x 2-1/2" Rating: Class V Maximum gross trailer weight...
Installation Notes:
No drilling required for installation
Spare tire will need to be lowered or removed temporarily for hitch installation
More Information >Videos
for Trailer Hitch
Help Articles
for Trailer Hitch
Expert Answers
for Trailer Hitch
The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…
view full answer...I agree it is the right time to upgrade to a Lithium charger/converter as not all are Lithium compatible. I recommend using the Progressive Dynamics Mighty Mini AC/DC Panel and Converter/Smart Charger - 60 Amp #PD4060K which is a replacement for…
view full answer...A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…
view full answer...From what I could find it looks like your 122R (red) and 122Y (amber) lights measure…
view full answer...I&…
view full answer...Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…
view full answer...Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846.…
view full answer...If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…
view full answer...Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…
view full answer...You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and…
view full answer...Filter Products (4)
Contact and Help
What our customers are saying:
I purchased one of your hitches for my SAAB 9-5. The hitch fits my car perfectly and is barely visible, which maintains the sporty look of my car. The hitch is a top quality product that I would definitely recommend to my friends. I was really impressed by your website and various installation videos. They were extremely helpful. My only suggestion to you would be to include a few bolt leaders with every installation package. I didnt realize I had to order them separately until after the hitch was delivered and I had started the installation. Thank you for a great product!
John
Waterloo, ON