1989 Jeep Doors

On the Jeep Wrangler and Jeep Truck models the steering wheel does not actually lock with the ignition in the off position, it just has a loss of power steering-which is likely what you're experiencing. Jeep removed the steering wheel lock from…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

The Replacement 2 inch Hitch Adapter, part #853-7489, you asked about is an adapter, that Thule says will fit TH9028, TH9029, TH9030, TH9031 and TH934XTR bike carriers. They have the threaded hole in the shank that aligns with the hole on the…

You can use an isolating diode kit like #48955 to prevent tail light back-feeding in your flat towing set-up. Each stop and turn circuit (4 in total) will need a diode to allow signals to travel in only one direction, without back-feeding to the RV.

The Bestop Element Upper Doors, part #B5179515, that you referenced does fit a 1993 Jeep Wrangler, but it does not fit the 2009. The proper part number for the 2009 is #B5180535. This is for the upper door. If you need the full door, we have that…

For your 2022 Jeep Wrangler, the twist locks (the base plate tabs) will indeed connect to the end of the arms on the etrailer SD Non-Binding Tow Bar #e34ZR. You'll connect that directly to the Invisible Base Plate Kit #e98948. It's somewhat…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Whether or not you can flat tow with a Jeep bumper is really up to the manufacturers testing; some of the big names like MetalCloak or Poison Spyder have bumpers with D-ring attachments that can be used for flat towing connections. This is great…

The Roadmaster diode kit part #RM-154 does fit your 2021 Jeep Wrangler with LED taillights. Since there isn't a plug and play type of wiring kit like trailer wiring this would be the way to go. We have the similar kit part #RM-15267 which comes…

You will have to verify that the Westin Grille Guard is one that came off of a 2001 Toyota Tacoma and would be part #40-0905. Every grille guard is made differently to match the vehicle and the hardware kit. You can't just take the hardware of a…

This part is not specified for a 2001 Tacoma, so it is possible that the original owner may have installed it by other than the approved method intended by the manufacturer. The Westin Sportsman Grille Guard, part #40-1605, is specified to fit all…