# 1
Demco Autoslide 5th Wheel Hitch w/ Slider - Single Jaw - Ford Super Duty Prep Package - 21K
Ford F-250 Super DutyVery high quality product. Used on a extended cab short bed F250 and the sliding mechanism provides plenty of clearance between the Fifth Wheel front and the truck's cab. Fits Ford's factory fifth wheel bed mount holes perfectly. Used to tow a 42' fifth wheel regularly. Foot print is small enough to allow me to retain my tool box in the truck during towing. The hitch is heavy! Do not plan to try to install with one person with out an engine hoist or gantry crane. Two strong people can, but extreme caution should be taken as the hitch weighs nearly 300lbs and is awkward.
2022 Ford F-350 Super DutyI have a F350 Super Duty Short bed. This slider works as expected. The ease of backing or tight turns makes this product excellent without the need to pulls pins for extension. I can remove or install in 7 minutes without a problem without any assistance. I am pulling a 44 foot trailer and have not experience any chucking or sway even in windy conditions. Tows very smoothly
# 2
Demco UMS Double Pivot 5th Wheel Hitch - Single Jaw - Ford Super Duty Prep Package - 21K
Hitch is nice and makes me feel more comfortable being a more novice RV'er with the large steel bar that acts as a secondary safety, unlike one of the other big brands that just has teeth that close around the pin. Assembly took a couple hours of blood and sweat even though it really is very easy.... You have to make time to torque about 20 or so bolts, but that's pretty typical of anything you plan to drop up to 21k pounds on and jerk around all over the country. Install into/out of the truck bed is now a 5 minute project thanks to a block and tackle in the garage ceiling. Extremely easy to put in or remove as long as you have an overhead weight bearing device of some sort. Beyond my experience with dragging a 17k pound RV with it, the mfgr is VERY responsive if you call for help. I was missing 1 washer upon assembly and the sticker decal was damaged in shipping but the MFGR had new ones in my mailbox in 2 days at no charge. They are also VERY good on tech support. The only caution I have on this is make 100% sure you know what grade bolts you have and what you should torque them to. Novice mistake: I rated the bolts based on the chart in the instruction guide but I rated on head size, not the diameter and thus I over-torqued. Luckily I did not have the means to torque to the actual higher spec or I would have snapped them at 250ft-lbs. If you have any questions on correct torque, call the mfgr and as for tech support! As for usage experience: Carry a long stick with you. We end up on crooked camping sites frequently and the only issue is that while this hitch moves ALOT to accommodate, sometimes you may get up under the pin-box and you just can't get the hitch to snap shut. Having a long stick on-board will let you push on the spring-loaded part and cause it to snap closed. One last thing from experience: lube, lube, lube. Keep the thing lubed as per the manual and do not be stingy with it on the parts that slide and grab your king-pin. It helps out drastically in getting it to snap closed on the 1st try. As for lubing the top plate, everyone is using those plastic lube discs these days. They work fine BUT: They WILL cause you a bit of grief in getting the pin exactly where it needs to be to snap closed on occasion. The hitch has enough wiggle room to accomodate them but it is not 'designed' for it, so once you're 1/4" higher out of the hole than spec, sometimes you will have to play with it to get it shut. If you ever find yourself just TOTALLY unable to get it to close on the pin, put your jacks back down and pull out from under your trailer. I totally destroyed one of those plastic discs a week ago and spent 40 minutes fighting and cussing at the thing b/c it wouldn't close on my pin far enough to put the safety pin in the handle... I finally yanked the hitch out from under the trailer and I had caught the lube disc at an angle on the 1st try and it had ripped a gash in in. That extra misplaced material up under there was preventing me from being able to secure the pin. Aggravating: Yes. But I kinda like it. You will KNOW that there is an issue with your current hitching job with this thing. It can be unforgiving at times but when I have $80k of truck and $110k of RV depending on it, I'd rather it be unforgiving and tell me in a loud voice: "You screwed up your mount attempt, try again" than to get to the end of an entrance ramp and have the trailer come down on the truck bed. If I had to buy one again, I'd buy the same one.
Very simple install. Very well built unit. Had to remove 1 shim on 3 of the feet because the handles were way too tight. Had ro use a rubber mallet to turn them at first. After removing the shims, it is perfect. I purchased a small master lock to replace one of the cotter pins for the safety pins so that noone steals the hitch. No noise while driving with just the hitch installed at all. I have not had a chance to tow anything as of yet--- pick up my 40' 5er wed! Seems to be a very well made, good looking, compact hitch. This was installed in a 2018 F350 long bed dually woth the oem under bed puck system.
# 3
Demco Autoslide 5th Wheel Trailer Hitch w/ Slider - Single Jaw - Underbed - 21,000 lbs
This hitch has been used daily since i purchased it. I deliver fifth wheel travel trailers all over the country. This hitch has worked flawlessly from day one. This hitch is one of the only products that I've ever bought that is exactly what it was described to be. Im not one to do reviews, so the fact that im doing this one , in itself, says a lot about the quality of your product. The design and looks are much better than any other hitch ive seen. It just looks better in the truck bed than others do.
Instructions left alittle to interpretation when it came to hitch height in the bed of the truck. For a f350 super duty it is the medium set up. Save you some time and effort. Other then that it looks great and will be testing it out this weekend.
# 4
Demco Autoslide 5th Wheel Trailer Hitch w/ Slider - Single Jaw - Above Bed - 21,000 lbs
This review is for the Demco Autoslide 21k and accompanying OEM rail adaptor I purchased for a 2020 Ram 3500 Megacab DRW. I've owned it one year. Overall, the hitch performs as I expected. It is high quality, very sturdy and seems like it will last for a long time. I had it installed at the dealer when I purchased the truck. It automatically slides to protect the cab in my 6'4" bed without any incidents. I tow a standard fifth wheel RV. There are a few negatives, which are not necessarily shortcoming of the product but, instead, necessary evils to allow me to have a short bed. First, it is BIG and BULKY. I believe this is just a function of the mechanism required to allow the autosliding feature and I am not really sure there are any other lighter alternatives with this feature. The fact it requires two parts (OEM Puck Rail and hitch), make it even more bulky. It takes up almost the entire bed and prevents most auxillary tank / tool box combos from fitting. Even standard size storage bins will not fit in my bed. I would prefer if they had a custom OEM all-in-one hitch for my truck like they do for the Ford. It adds significant weight, which decreases carrying capacity, which can be at a premium in hauling a heavy fifth wheel. I've never even tried to take it out of the bed due to the weight and difficulty. I also am not very happy with the adjustable catch plate design. It requires significant manipulation loosening and tightening 8 nuts when hitching and unhitching. This requires a step ladder to reach the nuts. I also found out after the fact that it does not come with the right size catch plate attachments for my hitch and I had to purchase a separate part, which added unexpected expense and delayed my taking the RV on its first trip. Overall, I am satisfied with the hitch.
I wish the place I bought my camper would have recommended this from the start. Makes owning a 5th wheel so much easier!
# 5
Demco Recon 5th Wheel Trailer Hitch - Single Jaw - 21,000 lbs
I like it’s design and how it sits in the bed. It seems to want to rotate some while pulling. I see some reviews that other people are having this problem also. Some have put a bolt down through the base into the truck bed. I haven’t wanted to do that as of yet. Otherwise I like the hitch.
Easy to set up and use I borrowed a buddies cause I bought a camper and didn’t have a hitch set up in the bed of my truck just had the goose neck ball pulled real nice so I order o e just like it
What our customers are saying:
"You folks are fast. Thank you very much."