# 1
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 12" Long - 5,000 lbs
The receiver is exactly what I was looking for. Put it on a 2016 chevy traverse and it is the right length for pulling a trailer. Looked at 6 1/2 inch, too short. Quality is good also. I give it 4 stars.
Should work great! Had to extend the hitch since the bike rack hit the bumper on the Traverse.
# 2
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/2" Long - 7.5K
EZ installation, plan on towing my 1932 plymouth coupe to car shows around the state.
Clean finish look and easy to install. If you order one read closely. It comes with a pin for it already. No meed to order one separately.
# 3
Draw-Tite Ball Mount for 2" Hitches - 2-3/4" Rise, 4" Drop - 9" Long - 7.5K
Should work great! Had to extend the hitch since the bike rack hit the bumper on the Traverse.
The receiver is exactly what I was looking for. Put it on a 2016 chevy traverse and it is the right length for pulling a trailer. Looked at 6 1/2 inch, too short. Quality is good also. I give it 4 stars.
# 4
Ball Mount Adjustable with Sway-Control Tab, 6,000 lbs
I have not used yet.
The ball mount did not fit onto the shank. This was a very disappointing experience.
What our customers are saying:
"Your internet site is very well organized and easy to use...My order was shipped very promptly and included everything I ordered...All in all this was a simple procedure for what can be a complicated order. I would use your company again or recommend you to others. Your selection was broad and your prices fair."