2000 GMC C/K Series Pickup without factory Tow Package Brake Controller

Features:

This unique brake controller mounts on your trailer instead of in the cab so you can tow your trailer using any truck. You'll control your settings from the handy key fob remote.

Installation Notes:

You need item ETBC7L ($112.38) to install your controller.

Features:

The large, digital, LED display and clearly labelled buttons on this proportional controller make it easy to use. Includes 3 levels of boost, a slide-bar manual override, built-in short circuit protection, and automatic leveling.

Installation Notes:

You need item ETBC7 ($142.23) to install your controller.

Some models have the brake (blue) and hot lead (orange or red) wires already ran to the rear of the driver side frame rail. However, these wires are hard to access and additional wire will be needed. We still recommend using part ETBC7.

You may also need a 4-Flat connector to complete your wiring.

Features:

This proportional brake controller is designed to keep towing simple. Includes an LED braking indicator, a slide-bar manual override, and a knob to adjust braking power. Mounts easily within a 90-degree vertical range.

Installation Notes:

You need item ETBC7 ($142.23) to install your controller.

Some models have the brake (blue) and hot lead (orange or red) wires already ran to the rear of the driver side frame rail. However, these wires are hard to access and additional wire will be needed. We still recommend using part ETBC7.

You may also need a 4-Flat connector to complete your wiring.

Features:

This time-delayed brake controller is designed to mount at any angle, even upside down. The controls are all up front for easy access, including a slide-bar manual override and a thumbwheel for braking output. LED indicator shows your braking status.

Installation Notes:

You need item ETBC7 ($142.23) to install your controller.

Some models have the brake (blue) and hot lead (orange or red) wires already ran to the rear of the driver side frame rail. However, these wires are hard to access and additional wire will be needed. We still recommend using part ETBC7.

You may also need a 4-Flat connector to complete your wiring.

Features:

This brake controller likes to keep things simple, with a thumbwheel on the front to adjust the output settings and a lever on the side for the sensitivity. The digital display is large and simple so you can read it with just a glance.

Installation Notes:

You need item ETBC7 ($142.23) to install your controller.

Some models have the brake (blue) and hot lead (orange or red) wires already ran to the rear of the driver side frame rail. However, these wires are hard to access and additional wire will be needed. We still recommend using part ETBC7.

You may also need a 4-Flat connector to complete your wiring.