2022 Can-Am Defender ATV-UTV Axles

The Replacement 7 Quart Vertical Pump Assembly #LC251910 is the Lippert part number 731445 you mentioned needing. The 251910 was the old part number which was replaced by the current 731445 number you found.

The American CS6000XL that you referenced is no longer available and there isn't a direct replacement for it but the closest solution as a replacement would be the Progressive Dynamics RV Control Center part #PD4560K18LS8 which as the same…

If your rod is 1-1/4" diameter, then it sounds like you have a 12K Bulldog Trailer Jack for which the Replacement Screw and Nut Kit part #BD500217 at 17" long x 1-1/4" diameter most closely resembles the Replacement Rod and Nut Kit…

I attached a picture that has about every dimension you could want for the part #BD500217. The overall length is 17 inches and the diameter of the screw is 1-1/4 inches.

Hey Matt we still have that screw kit. It is the Replacement Jack Screw and Nut Kit for Bulldog Sidewind Trailer Jacks item #BD500217. This is designed to fit Bulldog series 182 jacks from 2003 to present with a 12,000 lb capacity. I have linked a…

All of the sidewind jacks like the part #PSRV20000103 will have an outer diameter of 2 or 2-1/4 inches. This one happens to be 2-1/4 inches. You would have to open up the lower hole to match the correct size of the larger jack. A qualified fabricator…

If your trailer has 12k capacity Bulldog brand jacks then yes, the part #BD500217 would be the correct part you'd need. If instead they are Bulldog 10k jacks you'd want the part #BD500250 instead.

Hey Dave, thanks for reaching out! The Erickson Round D-Ring Tie-Down Anchor #EM59110 has a capacity of 1,200 lbs and is not going to be strong enough to cinch down your Polaris RZR securely. You need the CargoSmart Anti-Rattle D-Ring Tie-Down Anchor…

You can replace the Center Section #C-52 for the Curt Folding Gooseneck Trailer Hitch #C61332-52 on your 1999 Ford F-250 Super Duty. I have attached a picture with the bolt hole dimensions of the plate so that you can confirm that it will bolt…

Yes we do, the correct oil seal you would need is the part #10-56 which I verified has same dimensions as the 295924 that you have now.

Hey Kurt, thanks for reaching out! For your application I recommend the Equalizer Suspension Bolt with Locknut #7-182-6-112. This is 5" long, but it does have the 1" diameter and comes with the locknut you're wanting. We don't have…

Hello Jose. Our best option for replacing your Power Converter Model CS6000XL is the Progressive Dynamics RV Control Center part #PD4560K18LS8. The American CS6000XL that you referenced is discontinued, so this will be our closest option for…