2014 Bobcat 3400 ATV-UTV Axles

The lift kits we carry fit with specific axles; the #K71-725-02 is a tandem axle application and will give a 3-1/8" lift and is compatible with side-mounted #12 Torflex axles with 5,500-7,000-lb capacities. If that is what your axle is, this kit…

Hey Mark. The Torflex Lift Kit #DX56CR is specifically for Dexter #11 Torflex axles and would not be compatible with your Lippert Axle. I'm pretty sure at this point Lippert dropped all of their lift kits for torsion axles but if you can send me…

I added a photo which shows the location of the heating element of the Atwood Water Heater GC6AA-10E for you. It is item number 17 in the diagram. Atwood does recommend having a professional do the job if you are replacing it due to its location.

I have an option for you, but there is not a Lippert lift kit specifically for tandem axles. Instead you would just use two of the axle riser kits (1 for each axle): - Axle Riser Kit - Single Square Torsion Axle #LC382741 (works with Lippert 3,500…

Hello Jim, thanks for reaching out. We do offer lift kits that can be used with the Dexter Torsion axles. Do you happen to know the weight capacity of the axle? The S/N seems to indicate a 3,500 lb axle but please do confirm. We offer lift kits for…

The thickness of the angle steel of The Dexter Axle Torflex #11 Axle Side-Mount Frame Installation Hardware Kit Item #DX57FR is .209” (+/-.09).

The Dexter Torflex Lift Kits like the Tandem Axle #K71-725-02 that you referenced are only confirmed to work with Dexter Torflex axles. It's possible that the spacers will fit with your AL-KO axles but this has not been tested. The spacers for…

We do have a lift kit for your Lippert 7K torsion axle but the Dexter Torflex Lift Kits like part #K71-725-02 are designed to fit specific Dexter torsion axles. For example, the above mentioned kit will only fit a #12 Torflex axle that has a 5,500 -…

I attached a link to this page that has the install instructions for the Axle Riser Kit #LC382741 that you referenced.

I went out into the warehouse to measure the Lift Kit #K71-725-02 for you. The holes measure 9 inches on center and 9-1/2 inches on center. I've attached a photo to assist.

I sent your axle info to Dexter and they were able to determine that you have a set of 7k Dexter Torflex axles so the correct lift you need is the part #K71-725-02 which will give you a lift of 3-1/8 inches.

Yes, the Torflex Lift Kit #K71-724-02 is compatible with your #11 Torflex axle. The note about the 3" high profile bracket is corresponding to the brackets on the axle and not the Trailer Hanger #DX57FR. Your brackets appear to be 3-3/4"…