Both the Jensen JWM6A and the current model, part # JWM62A are classified as double-DIN head units, which will both use the same sized rough openings in a vehicle dash. The old # JWM6A and the current model
# JWM62A both use the same pigtail, as you can see in the provided photo that shows the pigtail pinout for both models side by side.
The # JWM60A and the # JWM62A are the same unit, they're just manufactured in different countries. Because there isn't any discernable difference between... view full answer...
I checked out the specs of the Shurflo 4008-101-F65 and the Seaflo Diaphragm Pump for Boats and RVs # SE58FR would be a great replacement as it has the same flow rate of 3.0 gallons per minute and has same PSI rating of 45. view full answer...
So we don't have a chrome or stainless flange for the # BUL101CB so the closest option might be the part # UCL60CB which is a similar 3 inch diameter clear utility light with a chrome flange. view full answer...
I reached out to Lippert and your 346005 control module was replaced with the Replacement Control Module for Lippert Ground Control 3.0 Leveling System # LC85ED. To use this control module they said you must have the Control Panel # LC421484 otherwise it will also need to be upgraded. view full answer...
You will need to measure your screen door on your 2015 Winnebago class A motorhome to ensure you select the correct replacement slider from the list below.
Screen Door Slider # 37211175 (12" wide x 12" tall)
Replacement Slide for P-Series RV Screen Doors # A77020 (11-7/8" wide x 11-11/16" tall)
Replacement Slide for Elixir RV Screen Doors # A77016 (10-3/4" wide x 12-1/8" tall)
If you have a different measurement for the slats between your screen door please let me know along with the... view full answer...
We do have replacement AC shrouds for your Coleman Mach Unit. You will want the MaxxAir TuffMaxx Replacement Shroud - White # MA00-325001 which is a confirmed fit for your AC unit. While you are replacing this, I also recommend you add the Start Capacitor for Advent Air RV Air Conditioners # ACMSCKIT which will allow your AC to start without requiring extra amperage, so it will start the first time and every time you need it by storing the energy needed for that start power draw. view full answer...
For your 2008 Winnebago View, it sounds like you want to replace the plastic shroud on your AC unit. If this is the case, then you have a Coleman Mach system and the correct replacement shroud is the MaxxAir TuffMaxx Replacement Shroud - White # MA00-325001.
If this is not what you were referring to let me know and give me some more info so I can be of further assistance. view full answer...
We have a number of replacement RV stereos available, please review the attached link. A replacement option to the IRV33 and IRV34 is the iRV64, # IRV64FR. This double-DIN stereo plays audio from radio signals, CDs, DVDs, and devices connected through Bluetooth, an auxiliary cord, or an HDMI cord with 3-Zone output plays music in separate areas. This has a wireless remote control included but also has option of the iRV App that lets you use your phone to control stereo. view full answer...
According to Progressive Dynamics, their # PD4645V Replacement 45A converter would be the proper replacement for your Parallax 7345 power converter. The unit is designed as a direct replacement for the converter in your existing power center/electrical panel. view full answer...
It looks like you will need to replace the entire light assemblies on your 2008 Winnebago Adventurer 35L as the lens mounts for the Optronics MCL0028 # A0028AB uses a different mounting style than the lights on your Adventurer. You current lights are discontinued and no longer available.
I recommend replacing your current assemblies with the Amber LED Clearance Light # MCL0030ABB and Red LED Clearance Light # MCL0030RBB. These LED assemblies won't require you to replace bulbs like your... view full answer...
Thanks for all of that info, and for your Kwikee steps, the part number 902508000 means you have a 25 Series step, and the because the sixth digit is an "8" that means yours is a was built between early 1999, and late 2005 to early 2006. That means your steps do not have the IMGL (integrated motor / gearbox / linkage) that Kwikee began using after that.
So the motor alone for these pre-IMGL units are not available by themselves, which means you'll have to upgrade to the new motor and... view full answer...
The Replacement Steps, Motor, and Control for Kwikee RV Electric Steps # LC365837 are the correct replacement steps for your Kwikee 902509100. If you are also wanting a new switch and sensor you will need the Complete Assembly # LC3658373 view full answer...
You will need either the Phoenix USA Rear Wheel Center Cap Right Hand Thread # PXQ2010XL or Left Hand Thread # PXQ2010L if you have a 6-1/2" wide hub. Otherwise you will need the Right Hand Thread # PXQ2020 or Left Hand Thread # PXQ2020L if you have a 8-1/4" hub diameter. Based on your images it does appear you have the 8-1/4" diameter hub but this is something you will need to verify. view full answer...
The Voyager RV LCD Observation Monitor # VO34FR will replace your current monitor and uses the same connection types so there are no adapters needed. We have the Rear Camera # ASA64YR which uses the same style connector. This camera works with both wired and wireless camera systems so it does have an antenna but it will work solely with your current wiring. Here is a list of our current side cameras you can use.
Voyager RV Side Camera - Driver's Side - Gray Primer # VCMS12LGPR
Voyager... view full answer...
The Jensen RV Stereo # JWM60A is a great option to replace your the Jensen AWM960. They feature very similar dimensions and capabilities but the connectors are not exactly the same so it won't be a plug-and-play replacement. However, it is still an easy install and I have attached an image from the installation manual showing the wiring functions that you can use for reference. I have also attached a few product review and installation videos that you might also find helpful. view full answer...
Based on what you are describing, it sounds like the touchpad has died or is malfunctioning and needs to be replaced. The correct replacement is the Replacement Lippert Touchpad for Kwikee Level Best Hydraulic Leveling System # LC68UD. view full answer...
It sounds like you're looking for just the handle and cable for the waste valve system on your 2021 Winnebago Micro Minnie Travel Trailer and for that we have options from Valterra with different cable lengths:
72" - # TC72PB
96" - # TC96PB
120" - # TC120PB
I don't know what exactly came on your trailer so you'll need to determine the cable length needed for your application. The good news is that you can trim the cable to whatever length you're needing so if one of these kits is slightly... view full answer...
Go To Results