Hello Leigh, thanks for reaching out. The correct lift kit for your camper will depend on the weight capacity of your axle. For example, the Torflex Lift Kit # K71-707-01 is for #10 torflex axles with capacities between 2,300 and 4,000 lbs.
The tag on your axle should tell you the weight capacity. Comment below and let me know the capacity and I will get back to you and make sure you get the right kit. view full answer...
You are correct that these two hub and drums are exactly the same but one has a standard grease cap and the other has an E-Z Lube grease cap for E-Z Lube spindles, so both will fit 12" to 15" wheels. The correct one for you will simply depend on if you have an E-Z Lube axle or not:
- Dexter Trailer Hub and Drum Assembly for 2,000 lb E-Z Lube Axles # 8-257-5UC3-EZ
- Dexter Trailer Hub and Drum Assembly for 2,000 lb Axles # 8-257-5UC3 view full answer...
Hello Harriet,
Great idea, and great question. We have not installed something like that here at etrailer, so it took some research to find a way to make it happen. I am not sure of what the weight of the lid for the 2014 Livin Lite Quicksilver Camper 6.0, but I did find a video where a gentleman was able to accomplish this by using gas struts for a 1995 Jeep Cherokee liftgate which would be out part # ATL48GR, then you could use a set of the Gas Shock Mounting Brackets - 10 mm - Qty 2... view full answer...
The Alpha Systems Superflex RV Roof Membrane with Installation Kit, # AL37UV is not designed for canvass tent material used with pop-up style campers but over the top of solid roofs.
The Camco Pro-Tech Patch Kit for RVs w/ Rubber Roofs, # CAM41461 has been used successfully on the fabric of pop-up campers. view full answer...
We may have what you're looking for, for your 2014 Livin Lite Quciksilver, however to be certain I would need to know the size of window you're replacing.
For instance, we have the:
-Replacement RV Entrance Door Glass # VAL58GR which fits beautifully with the Valterra Entry Door Window Frame Assembly # A77051.
This window measures 12 1/2" wide and is 21 1/2" tall, so if this is the size of window you're needing then this'll work great for you.
If not, let me know what you need and... view full answer...
The 12-volt trailer feed, which is the pin that sits in the 1:00 position if you're looking at the front face of the 7-way connector on the vehicle is fed by the vehicle battery. If this connection isn't already made on the vehicle side, run a length of 10 gauge wire like # 10-1-1 which is sold by the foot from the 1:00 terminal to the vehicles positive battery terminal. You'll run that circuit through a 40 amp breaker like # 9510.
On the trailer side, you'll run the battery circuit from... view full answer...
Go To Results