Yes, the Progressive Dynamics Inteli-Power RV Converter and Smart Battery Charger # PD9280A would be an exact replacement for your PD9280 converter.
If you weren't just going to replace it and were going to troubleshoot the issue I recommend checking the output of the converter. It could be that the internal Charge Wizard is bad and not correctly reading the charge of your battery and thus sending more power than necessary to charge your battery. To test the output of the converter you'll... view full answer...
I checked with Furrion and the 7 inch and 5 inch monitor version of the Furrion observation system # FOS05TASF use part # FR79SR. The smaller 4.3 inch size use the part # LC776462.
The ball of the # FR79SR is 0.85" or 21.59mm and the ball of the # LC776462 is 0.60" or 15.24mm. view full answer...
You can use the Camco Single Stage Propane Regulator - 200,000 Btu/Hr # CAM59013, which is a fairly standard replacement regulator and will work well to replace your KLI 9000 since it is designed for low pressure items as it maintains a constant 11" w.c. propane pressure level. I was able to locate the inlet and outlet sizes of the KLI 9000 and this does match the 1/4" NPT female inlet and 3/8" NPT female outlet, so this will be the correct replacement for you. view full answer...
To add oil hubs and disc brakes to your 7,000 lbs axles, you will want the Dexter Disc Brake Kit - 12-1/4" Hub/Rotor - Oil - 8 on 6-1/2 - E-Coat item # K71-694-695-13. This kit comes with all of the necessary bearings, races, and seals needed to complete your installation.
You will also need brake lines and an actuator, I recommend the HydraStar Kit item # HBA16-252-82 which comes with the brake lines needed for a tandem axle trailer, wiring, the best actuator available, and a breakaway kit. view full answer...
Thanks for the picture! It looks like your Toy Hauler has 2-1/4" shackles. To replace and upgrade your wet bolts, I recommend the MORryde Suspension Upgrade Kit for Tandem Axle Trailers item # MR46ZR. These wet bolts have built-in grease fittings that make maintenance easier.
I have linked an installation video below.
I also recommended upgrading your Equalizers with a MORryde equalizer to soften up your ride. To determine which MORryde Equalizer you need you'll want to measure the... view full answer...
If you are unable to contact your trailer's manufacturer with your VIN to find the factory pin box model number there are some steps you can take which will allow you to determine what pin box model you have so you can purchase a new FlexAir.
To do this you will need to follow the steps in the linked help article, which I will go over with you. Start by selecting your pin box style like in the accompanying photo (which you will also find in the help article). You will then need to use... view full answer...
The Lippert Center Point by Trailair Air-Ride Suspension Upgrade # LC1565401 fits most trailers but I do have some things for you to double check just to make sure this will fit your 2018 Heartland Cyclone 4250 triple axle.
Your leaf springs need to be 1-3/4" wide and then when it comes to the equalizer you need the top bolt for your equalizer needs to be at least 2-1/2" below your trailer frame and the lower bolts to be at least 3" in width.
I've attached a review video of the system... view full answer...
While solar power is very helpful for RVing off the grid, they aren't quite at a level to power everything unless you install a whole farm worth of panels. Solar power isn't directly powering your appliances, but instead just recharging your battery bank.
Both of the Go Power Solar Systems # 342-75010 and # 34282185 you referenced will require 4-6 batteries each. Both systems are recommended for 159aH in replenishment a day (with peak conditions).
Pure Sine Wave Inverters like the Go... view full answer...
I'll go ahead and list out the options for you for replacement toilet seats for Dometic RV toilets, but we have no way of knowing what toilet is any specific trailer, so you'll have to match up yours with the correct replacement.
- Dometic 310 Series Part-Timer: Replacement Wooden Toilet Seat with Slow Close Lid - Tan # DOM23FR or White # DOM83FR
- Dometic 510 Series Full-Timer: Replacement Wooden Toilet Seat and Lid - Tan # DOM25FR or White # DOM85FR
- Dometic 320 Series Full-Timer:... view full answer...
The SoftStartRV Soft Start for RV AC Units # SSR54FR is designed to work with single-phase air conditioner units. If you remove the shroud there's a tag on the compressor that should state if your unit is single-phase or three-phase.
If you have an Advent Air unit then you'll want the Start Capacitor for Advent Air RV Air Conditioners # ACMSCKIT instead.
If you were replacing the start capacitor on a Furrion unit you would want the # FR45FR for a 14,500 BTU unit and the # FR65FR for... view full answer...
Thank you for that detailed information and what I can tell you is that when choosing leaf springs, the actual number of leafs isn't the most important thing, the weight rating and center-eye to center-eye measurement is what you need to know. I have added a cut out from the help article on double eye trailer suspension which I highly recommend reading.
We do not carry double eye springs rated for 8,000 lb axles and there is no way for us to know the rating of your currently installed... view full answer...
The SaltDogg Electric Hitch-Mount Salt Spreader part # 337TGSUV1B won't work with sand but we do have an option that will work with a salt/sand mix, the SaltDogg Electric Tailgate Salt Spreader part # 337TGS07 but it does however require a pickup. view full answer...
You can use the JR Holding Tank Heater # 372HTH-A on your 30 gallon and 45 gallon tanks but you would need to use more than one per tank. On the 30 gallon tank you'd need to use two and on the 45 you'd need to use 3. view full answer...
The Lippert 165046 upper slide assembly you have has been discontinued. We sell replacement parts for it but not the entire unit.
The Replacement Motor for Lippert Electric Coach Step item # LC301695
Replacement Control Module for Lippert Electric Coach Step item # LC301702
Replacement Wiring Harness for Lippert Electric Coach Step item # LC301692
Replacement Gear for Lippert Single and Double Electric Coach Step item # LC301696
The closest thing we have size wise is the Replacement... view full answer...
Sure thing, though we don't have any way of knowing what equalizer is on any one 5th wheel trailer, so to get the correct upgrade for your Heartland RV 5th wheel you'll need to do a wee bit of measuring. It's pretty simple though, as you'll just want to measure from center to center of the bolt hole, and from the center of the equalizer to the center of the top bolt hole. I have added a photo which shows an example of this for the Road Armor Shock Absorbing Equalizer Kit # LC696740.
As... view full answer...
If an RV toilet is emitting a bad smell that just means the gaskets are failing. You can replace the gasket between the floor and toilet with part # Q23653VP and the flush gasket that holds water in the bowl and prevents odors with part # DOM63FR.
Most toilets require 11" of clearance from the center of the drain back to the wall, except for the 300 series which only requires 8.5". Since you don't have the extra space you would need to stick with a 300 series with either the White # DOM64FR... view full answer...
While we don't have a way of knowing what awning you have, I can tell you how to choose the right replacement support arms, so long as your awning is a Solera awning. To do so, all you have to do is measure the length of the wall mount, which will tell you the correct size for the arm assembly, and what we have is the following:
- 69 Inches: Solera 69" Standard Flat Awning Support Arm # LC281154 view full answer...
Without the model number of the speakers I wouldn't know the actual dimensions of them since there's no registry for what is used in a trailer. That being said I can give you the dimensions of the Jensen Marine Speakers # MS5006BR that you were looking at and you can verify if it's a match.
These speakers have mounting holes that are 3-3/4" from side to side or top to bottom and 5-1/2" diagonally. The exterior cover is 6" in diameter and requires a 4-3/8" wide x 1-1/2" deep cutout hole. view full answer...
Yes, the Replacement Dexter Bolt-On Shock Kit for 2-3/8" or 3" Diameter Axle # K71-697-00 is the correct shock absorber for your 2015 Heartland RV Bighorn 5W.
This replacement shock absorber will work with 2-3/8" and 3" diameter axles that have 1-3/4" wide springs. You'll need to use one kit per axle as well. view full answer...
Go To Results