Your sewer hose can slide out of the bumper or drag on the road if the end isn't covered, especially on rough roads. This 4" bumper cover caps the opening while the center hole allows airflow so the hose stays in place and ventilated.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Hi everyone. Steve here with etrailer. Today we're taking a quick look at an RV Designer replacement bumper cover four inch square. So folks, as you know, this just simply pops into the end of that four inch by four inch square to bumper on the back of your RV or a camper. And a lot of times, there is that space in there for you to hold sew hoses and those kind of things. Well, this is a replacement cover.
You push it in. All these little fins here are gonna hold it in place. You have a little square hole for ventilation and you can also use it to pop it back out when the time comes as well. So there's no drilling or welding required. There's very simple to install.
Just pop it in, pull it out whenever you are taking it apart. Heavy duty construction of hard plastic. That is the RV Designer bumper cover replacement in four inch square. I'm Steven, thanks for watching.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.