Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Throw this storage cover over your horse trailer to protect it from rain and snow while you're storing it in between trips. Cover wraps around the bottom corners of your trailer and secures with integrated straps so it won't flap in the wind.
Features:
Specs:
You're worried about your horse trailer getting wet and dirty in storage before you need to transport your horses again. Whether you're storing your trailer in the rainy northwest, snowy north, or humid south, this weather-resistant cover is designed for use in extremely wet climates so your trailer will be protected. When you keep your trailer covered, you are less likely to need to wash and wax it in between trips. And if you want to trade your trailer in for a newer model later down the road, this cover will help maintain that resale value.
The 3-ply SFS AquaShed top panel reduces moisture buildup that can damage your trailer over time. It also beads water when it rains to stop it from pooling or freezing, which eliminate the black streaks and corrosion you tend to see on the sides and roof of your trailer. And when the rain stops, the fabric dries quickly to minimize the development of mold and mildew. The top panel blocks the roof of your trailer from mild sunlight as well, protecting the cover from cracking and fading.
How to Measure Your Horse Trailer
To determine if this cover will work for you, measure the overall length of your trailer from the very front to the rear bumper, making sure you're accounting for any gear on the back. The cover isn't meant to fit over the kingpin of your trailer, so don't include it in your measurements. Then measure the overall height from the bottom of the trailer to the top. Do not include any AC units, vents, or antennas in your height measurement, as the cover is already designed to accommodate them.
Securing the Cover onto Your Trailer
First unroll the cover and carefully spread it evenly around your trailer, making sure you don't pull too hard and tear the fabric. The cover is labeled with "front" and "rear" to help you position the cover correctly on your RV.
Once the cover is in place, wrap the elasticized hem on the cover around the bottom corners of your trailer to remove any excess slack in the material. Attach the included cinch rope and pull on them until the cover fits snugly around the contours of your trailer. And then toss the weighted straps underneath your trailer to the other side and buckle them together, which keeps the cover secure and prevents it from flapping in the wind and damaging the paint job.
And if you need to grab supplies, you can use the zippered panel on the passenger's side to easily access the interior of your horse trailer without having to completely remove the cover. You can also unzip the entire panel on the back of the trailer so you can open the tack door and load and unload gear.
Customer Satisfaction Score:
90% were satisfied with this product
10% of customers were not satisfied
Ratings & Reviews
I think that the cover is a great cover and I would recommend it to customers who is interested in getting a well built cover that will hold up the weather.
My wife and I just installed it so I can’t speak to longevity.
We are in our 70s so up on ladders to drape it over was a bit dicey
Cover seems to fit fine.
Recommended instructions with photo would be helpful.
Measure , measure, measure your trailer before purchasing. I thought I had a 6x10 trailer and it was actually larger than that when measured the outside. Result was buying too small of a cover and had to return it. Great News though, there was no hassle and no issue with returning it. 5 stars is because they were so helpful with fixing my “assumption”. The cover is fairly light (14 lbs) and easy to handle.
After a year of the Florida weather, I will say it has been nice having the cover. I ordered the larger version to fit my V-nose 7x16 extended height trailer. It sucks to cover it by yourself, but if you have a method to the madness, it isn't as bad as it could be. I would've liked to see more reinforcement at the corners to avoid tears and punctures. It could also use a better system to tighten it down around the middle of the trailer. The belly ( under the trailer ) clips have held up and are fairly easy to tighten down to avoid flapping around. It does have some wear through areas which I will use heavy duty tape to try and slow down the damage. All in all, it has done its job to this point, and if you break down the cost per month to date, it is doing ok for the price point.
I just installed the ADCO trailer cover on my 2023 Rockwood GeoPro G19FDS.
The cover fits great and was easy to install.
The cover quality was excellent.
Our cover just arrived just in time before the snow storm! We will watch how it will hold up through the upstate NY winter!
A very good cover easy to install and stores well this is the second one i bought higly recommended
The cover does it’s job. There were three places where it has already ripped in only a year. One place was my fault but difficult to prevent. It ripped where the drip tray ended. I had to tape some cardboard over the edge to prevent further damage. Be sure to cover all pointy edges. Which it does say that in installation directions but the drip tray isn’t “sharp” in my opinion but it was definitely enough of an edge to cause a hole. The other two were at rounded corners and should not have ripped. They were at a corner of the trailer and a running board and there was a part of the cover stretched to turn a corner. I haven’t reinstalled for the year but I am hoping I can repair the damage and reinforce the corners to use it again.
Good service, thanks
Product arrived on time Fits my gooseneck perfect Easy to order and they offer lots of information for you to decide what works best
This cover has kept my trailer clean and dry over even our severe winter weather and so far the wind has not destroyed it as some of the other covers I have bought . So glad I found one !
I received my order in a very short amount of time and am very pleased with the customer service. I was emailed when it shipped and again when it was received at the post office. I was able to put the cover on my trailer my myself in under 25 minutes. It was easy and fits the trailer nicely.The cover seems very well made:)
This gooseneck trailer cover was delivered quickly. The instructions were simple and helpful. The cover went on with all straps in place in about 15 minutes without needing a second person to assist.
I love this cover however it took almost an hour to put it on my trailer because I lived in the very windy desert so the wind was throwing it all over the place and. It came with no instructions on how to best get it on which would have been very helpful. I left it on my trailer for about 3 months in the summer/fall and considering the wind and sun it held up well. It got a few rips because the fabric isn't very thick. Overall I am glad I made the purchase but there are some areas for improvement of the design that could make it easier to put on and the fabric could be a tad bit thicker.
The cover easily fit over my 26 foot goose neck (V-nose) enclosed car carrier trailer (even though it is made for a conventional horse trailer). The cover is very good quality and has already stood up to several thunder storms. Highly recommend this product.
Cover is very well made. Stitching and all buckles appear to be strong, as well as the tie down ears for the rope (provided) to pull out any slack. Once you get it going, it fits like a glove. I put it on myself, with the help of a ladder, and it took about 30 minutes. Very satisfied!!
With Sara's help we selected the perfect cover for my horse trailer. It fits perfectly. The tie-down straps are excellent.
It definitely takes two people to put it on, but it looks good and fits good and time will tell how good it will hold up under the Arizona sun
The last cover I purchased, exact cover, made it thru 7 winters before it needed mending. Decided it was time to retire it. I'm hopeful this new cover does the same.
Do you have a question about this Cover?
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thomas M.
12/21/2021
The Adco Cover Part # 290-46012 comes with a 2-year warranty. I will have Customer Service reach out to you.