Waterproof, backup camera with night vision has a 120-degree viewing angle to minimize blind spots and help prevent accidents. CMOS sensor creates high-quality digital video in full color. Durable, aluminum housing is corrosion resistant.
Features:
Specs:
California residents: click here
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Today we're going to be taking a look at the Voyager camera with LED low light assist. This camera would be great for a backup camera on your RV. It's very small and compact, it's not going to take up much room at all. It's not going to be very noticeable. It's going to feature high performance color optics and wide viewing angles. It's going to feature a built in microphone, so that way you can hear what's going on.
It's a really nice design of the unit. The unit features infrared LEDs that really help enhance low light performance. It makes it easier to see at night or in low light conditions. The unit's going to feature a completely waterproof design. It's going to be corrosion resistant.
The camera, you can see here that it's on a pivot point, so that can be adjusted to get the best angle that you need for your application. The camera itself is black in color. It does come with the butterfly mounting bracket. It's going to come with an adhesive foam gasket and it's going to come with the necessary mounting hardware. Wiring harness is pre-attached to the camera and it's going to come with that grommet to seal up the pass through location into the RV. When it comes to the overall dimensions, go ahead and get it squared up.
Front to back it gave us an overall measurement on an inch and a half. That's from the front of the camera to the back of the bracket. Overall height from the bottom of the bracket to the top of the unit was an inch and a half tall. The overall width from outer edge of the bracket to the same point on the other side is one and 3/4 of an inch. The mount holes on the unit are separated on center by looks to be an inch and a quarter. Then the camera body, just the camera it's nice square design, that's one and 1/16 by one and 1/16 and it has a depth of about an inch and a quarter.
The harness on that unit is going to measure about 40 inches long and it's going to have that standard four pin connector at the end of the cord that plugs into your RV's camera wiring system. That's going to do it for today's look at the Voyager camera with LED low light assist.
Info for this part was:
At etrailer we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.