# 1
Miro-Flex LED Clearance or Side Marker Light w/ Chrome Bezel - Submersible - 3 Diodes - Amber Lens
These are an exact match. Even the serial numbers are the same!! Not bad for replacement parts on an eleven year old motorhome. Customer service couldn't be better!! Thanks again, Skip
Perfect replacement.
# 2
Hot Dot LED Trailer Clearance and Side Marker Light - 2 Diodes - Red Lens
Parts are exact fit as I led parts
Exactly what I ordered and needed.
# 3
Optronics Flexible LED Light Strip - Weatherproof - White - 17' Long
Replace the LED strip under my Awning on my Jayco trailer with these and used shrink tubes to make the connections water tight also . Work really great!!
Great service! My order was shipped the same day as my order. The lights are high quality for a good price. Will definitely be using etrailer for my rv needs.
# 4
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Amber Lens
The nuts fit perfectly on the Morryde wet bolts, the clearance lights are the exact match for our Jayco Eagl, I like to keep a replacement on hand when 1 burns out.
I'm not sure I saw it in the listing, but these are in fact Command brand lights - exactly what Jayco uses on their trailers. I replaced almost all of my lights this year during a water damage repair (might as well right?). These were super easy install and being the same brand, used the same holes to mount back up. I elected to use wire nuts with them as opposed to the clamp conectors Jayco uses from the factory. Wire nuts worked great for them.
# 5
Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
Quite easy to install and fit my Coachman Freelander perfectly. The prior ones were not sealed, filled with water, and blew the fuse fuse. Beware of the cheaper version on Amazon as they have the same poor seal problem as the original lights which died after <5 years.
Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.
# 6
Thinline LED Trailer Tail Light w/ Reflector - Stop, Tail, Turn - Submersible - 11 Diodes - Red Lens
This part I received (#STL69RRXB 091523) turns out not to fit. Further, after taking off the existing part I find the part number is (#STL69RB 121821)
I used the item as a third brake light on my JK Jeep hardtop after removing the OEM spare tire rack. It is a high quality product and lived up to the description and on-line video. It really looks like it came new on the vehicle. I hooked it up using a trailer quick disconnect connector so I can remove my hardtop when I go out on the trail.
What our customers are saying:
"The lights are great! Only wish I had them installed today. I'll be back, Thanks for a quality product at a very reasonable price."