# 1
LED Trailer Light w/ Reflector - Brake, Turn, Tail - Submersible - Surface Mount - Round - Red
This trailer light was an exact match for my original equipment light and easy installation.
I needed a tail/stop light for the rear of my Fairmont railway motorcar and thought from your on-line description that this product would be satisfactory. I was right, it is a good size and bright enough to be very visible in bright sunlight. As you can see from the pictures, to make it match aesthetically I attached the lamp to an aluminum plate cut to fit in an old auxiliary lamp housing. The railway car runs in both directions hence has head and tail lights on both ends. I am very satisfied with this light.
# 2
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Red Lens
Exact replacement for Jayco running lights.
The light is identical to those oem on my mh. I bought this light as a spare so it has not been installed. I should connect it to 12v to ascertain it's status. The leads on the light are short at about 5 inches. Rating an item that has not been installed is not a good practice, but I received 3 emails from Etrailer requesting a rating.
# 3
LED Trailer Clearance or Side Marker Light with Reflex Reflector - 2 Diodes - Amber Lens
I'm not sure I saw it in the listing, but these are in fact Command brand lights - exactly what Jayco uses on their trailers. I replaced almost all of my lights this year during a water damage repair (might as well right?). These were super easy install and being the same brand, used the same holes to mount back up. I elected to use wire nuts with them as opposed to the clamp conectors Jayco uses from the factory. Wire nuts worked great for them.
The nuts fit perfectly on the Morryde wet bolts, the clearance lights are the exact match for our Jayco Eagl, I like to keep a replacement on hand when 1 burns out.
# 4
Triple LED Trailer Tail Light - Stop, Tail, Turn, Backup - Red and Clear Lens - Qty 1
Quite easy to install and fit my Coachman Freelander perfectly. The prior ones were not sealed, filled with water, and blew the fuse fuse. Beware of the cheaper version on Amazon as they have the same poor seal problem as the original lights which died after <5 years.
Command Triple LED Tail Light Review They work great once they are installed. I have 2002 Gulf Stream Ultra on a Ford E450 Frame. The problem is the actual installation. Command does not include install instructions. What may needed if converting from incandescent bulb to a LED system is a 12 Volt 50 Watt 6 Ohm resistor. Installing a resistor parallel between the Brake/signal and Common wire will be necessary to overcome the hyper-flasher bulb out detection system. This high power resistor needs to be mounted on a metal surface to help disapate the heat created. In my case, I mounted the resistor to 3/4 metal pipe banding. The resistor was suspended so that is would have great air flow. Furthermore, size of the light should be slightly larger than 14 w x 6 7/8 . In my case the tail light was not big enough to cover the old light screw holes. I made this work by centering the light and using lap sealant as a finishing water proof bead. After a long road trip and many signal turns and brake presses the tail lights do look and work great.
What our customers are saying:
"Great trailer roof vent low profile cover. I just built an extra garage with a 9 ft door and my trailer didnt fit by less than an inch with the original bubble cover. This new cover gave me an extra 1 1/2 inches of clearance and solved everything. Price and shipping was great too. Thanks for saving me. Its hard to measure the actual trailer height and I dont think I wanted a 10 ft door."