# 1
Curt A16 5th Wheel Trailer Hitch w/ R16 Slider - Dual Jaw - 16,000 lbs
The Curt A16 5th wheel w/ R16 slider is a great looking hitch. I received the hitch on May 11, 2023, replacing an older Reese 15K hitch with a slider lock bar. It was easy to finish the assembly and install. I immediately took my fifth wheel out, using the new hitch with the dual jaw locking system. The ride was amazing. The RV, which weighs approximately 10,000 pounds, loaded, did not buck or rattle, and responded perfectly to the turns, acceleration and deceleration with no issue. It was if there was nothing behind me. The only issue with the Curt A16 is the height. At its lowest setting, the nose of the trailer was up too high. However, by raising the tongue of the RV to its highest setting, I was able to remedy most of that issue. I am looking forward to my trips this year with the new hitch!
So far it works great. Only pulled in a short distance and backed it up into my driveway. Make sure you have help lifting this. Very Very heavy. Directions were average but got the job done. Love the extra turning radius on my short bed F250. Make sure all the parts are there. The handle to release the king pin off the hitch was not in the packaging. The box that the hitch and slide came in were all in tacked and looked good. Emailed etrailer and within a few hours they sent were processing the order for the handle. Arrived in 2 days. That's great customer service.
# 2
Curt A16 5th Wheel Trailer Hitch w/ Slider for Ford Towing Prep Package - Dual Jaw - 16,000 lbs
Curt A16 with Slider base for Ford OEM Pucks I went through a good bit of anxiety after trading my 2013 F-250 for a 2018 F-250 due to the height of the 2018. I did not pay close enough attention to bedrail and rear height and I was beside myself sick over it so this review might be a bit long while I explain my journey. I replaced a 2013 F-250 4WD with a Reese Pro Series 16K square tube slider universal mount with a 2018 F-250 with OEM pucks. I pull a 2015 Prime Time Crusader 315RST. I measured, I had boards with levels, mock up on hitch height, I read every forum and article I could find and still I was worried I had made a big mistake. Finally, I called eTrailer and talked to Molly and she had, (or went and got) plenty of answers as I had narrowed it down to the B&W BWRVK3370 20K Companion Slider and the Curt A12. I decided to not go for the “the most expensive is better” and went with the Curt A12 saving me about $300. The 20K B&W was the smallest they had and with an F-250 I would never really come close to that weight before I passed the GCVW limit so it made no sense. The Slider base for the Curt says it is the same base used up to 24K so if I ever do I can just buy the new head I believe. Ordered on a Saturday it arrived on Thursday at noon. No issues with shipping at all, the hitch came in 2 boxes strapped to a pallet. No damage like others experienced. Assembly took me about an hour because it is heavy and awkward to line up the slider linkage but all in all nothing too difficult. I set the hitch head mount at the 2nd from the bottom (18 inch) hitch height because I had measured the truck and camper and was worried about having 6 inches of clearance camper to bed rail. Turns out on a 2018 F-250 4WD at the 18-inch level on the hitch I have 8 inches all around and 7 inches at the highest point on the tailgate. After I installed the hitch and put the camper on the truck and applied weight I got about 3-4 inches of squat, which made the already rear high truck sink to near level. I do have more nose high attitude on the trailer than I had before but it was not terrible. I moved the height adjustment down to the 17 inch (lowest) today to lessen the nose high attitude by another inch and I have 6+ inches clearance still. The hitch. Like I said before I had a Reese Pro Series 16K slider and it was noisy as hell. Kingpin clunk starting and stopping, creak at every bump and turn. I put the Curt A16 in and took the trailer for a drive with the rear slider window open and heard nothing. Absolutely nothing. No start/stop clunk, no creaking, nothing. Hook up was very easy and the interlaced kingpin jaws make visual check very easy. Operating the slide takes a bit more effort but it worked fine and locked securely. It did not latch back to maneuver and then back again to towing automatically like the video without jostling the handle a little but I am sure it will once broken in and I grease it a bit more. The puck system was easy to adjust and make a solid connection to the truck with no play. I could not be more pleased with the hitch. Cons- The hardware was packaged like one would expect and it was all there but the bolt for the center connection of the slider linkage was different than the handle and passenger side joints. It is too small and caused a lot of play. I used it anyway but it allows play in the handle and not firm for unlatching. I will replaced it today and now it works great. eTrailer is now my go to store for trailering supplies.
2017 F250 curt A16 slider Ford prep package
# 3
Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
I purchased both the Curt A16 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs - C16120, and Reese Pull Pin Lock Plates for 5th Wheel Trailer Hitches - Qty 4 - RP58093 for my F350 SD 4X4 Crew Cab Long Bed. I'm pulling a 30' Retro 5th. Wheel and at times I pull my tandem axle UTV Trailer (Double Trailers) . I already had the rails installed in my truck, this fit right in and I used the new Pins and Lock Plates for securing to truck. I have pulled all over from South Dakota and the Northwest. The Hitch has performed Flawlessly. No bucking, nor clunking. Very quiet and smooth ride. I would recommend this set up to anyone for convenience of Hook up and Disconnect, Excellent towing, quiet, and the security of the lock pins. I use Disc locks to prevent access for bolt cutters.
I was fully expecting a hitch in excess of 100 pounds to show up in a destroyed box. This did not. They had taken the Time and effort to cover the box with an additional layer of cardboard and it must have had a million staples in it. It was almost comical, you will need a crowbar or large screwdriver to get it open. However, when I did finally get the package open I found a perfectly un scratched hitch with no missing parts. I have not pulled with the hitch yet but , it does look like it is going to perform great. I'm using this in a 2006 ram 2500 4x4 short bed pulling a 2015 forest river Salem and it allows 91 degrees of turning due to the clipped corners on the front cap of the trailer. I will be curious to see how long the rubber isolators last before needing replaced and if they are readily available. Also the curt sticker on the hitch was peeling off when I took it out of the box, would be nice to get that replaced.
# 4
Reese 5th Wheel Trailer Hitch w/ Square Tube Slider - Dual Jaw - 16,000 lbs
Arrived yesterday, box with hitch was broken, UPS driver said he taped it up. All parts look good. Plastic bag with small parts was torn open, 2 small parts missing, I can get them locally. I understand that there heavy Just need to be packaged better. Otherwise all ok.
Nice ride with this hitch . I was kind of on the fence about the pivoting but I’m good with .
# 5
Reese 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
This product gets a three based on shipping condition only. etrailer customer service and shipping time was excellent as usual. The shipment arrived 2 days after the order was placed, as promised. However, as others have noted, the product packing is poor. The boxes arrived with significant damage resulting in cosmetic damage to several parts. I haven't put the hitch to use yet but I am assuming it will work correctly. I will leave a followup after I use it.
The hitch arrived nicely packed in two boxes. Very easy to assemble and install on my existing bed rails. I took the RV out for a first run with the hitch, and it performed as advertised. It was a no fuss transaction and the hitch arrived on-time!
# 6
B&W Patriot 5th Wheel Trailer Hitch - Dual Jaw - 16,000 lbs
Product is very well made. Glad I went with B and W Patriot Hitch. Once the bed rails were installed the rest was a breeze. Now it's time to get a 5th wheel and hit the open road. etrailer, my go-to website.
I bought this hitch to replace a slider hitch from another manufacturer. I wanted something I could get out of the bed without help, and with the 2" offset, I can get plenty of angle in a tight turn, thus eliminating the need for a slider. So far this hitch is fantastic. Hook up is so easy. Handle moves with zero effort. Same for unhooking. As soon as it was installed, I did a test run, and it was rock solid. I tried to make it chuck when starting and stopping. It wouldn't do it. Zero slop. On that note, the tolerances are tight on this thing from the bolt holes to the legs that insert it into the rails. My rails we're not perfectly lined up and required a little dremel and foot stomping to get it in the rails. In summary, if your looking for solid, conventional, non-slider FW hitch, this one is a great choice.
# 7
Reese 5th Wheel Trailer Hitch w/ Round Tube Slider - Dual Jaw - 16,000 lbs
GREAT GREAT GREAT EXPERIENCE AND EVERYTHING THAT GOES WITH THIS WEB SITE.....PRODUCT TO PRICING TO SERVICE.....
Worked perfectly for my application, installation was easy and it has worked with no issues.
# 8
Curt E16 5th Wheel Trailer Hitch - Slide Bar Jaw - 16,000 lbs
After ordering rails for a fifth wheel that I had in an older truck, I was told the rails I ordered would work with my fifth wheel, however after installing the front rail, the fifth wheel would not work with the rails ordered. I ended up ordering a new fifth wheel plate. That was easier than removing the frame brackets I had already installed. It appears that there was a mis communication between the person I talked to with etrailer. Instead of a 1/2 day install it took a day and a half plus wait time for the fifth wheel to get to my address. However once installed it appears to be good.
The hitch worked great. Reason for the 2 stars is the package got delayed twice in transit and I had to reschedule the pickup of my fifth wheel. When I also received the package the main crossmember bar was bent at the mounting point. Luckily I was able to bend it back but UPS needs to get there act together.
# 9
Curt E16 5th Wheel Trailer Hitch w/ Rails and Universal Installation Kit - Slide Bar Jaw - 16K
We have the turning point pin on our rig so we had to get a wedge. I don't know if it was the wedge or the hitch but unless we were perfectly straight and level, we couldn't hitch up. Same with unhitching. After the 3rd time of not being able to unhitch without taking the entire head of the hitch off, we locked up the turning point and got a new hitch and do not use a wedge. Also, with only a bar going across, the pin seemed to wiggle around a lot.
Shipment was fast, installation was easy, very affordable.
What our customers are saying:
"WOW! I am impressed! I called to place my order and real person answered, spoke perfect English, albeit a slight southern accent, and my order was sent within a day, shipped quickly and I had it a few days later. I saved over a hundred dollars over local and installed it my self. I cant imagine how that they could do any better. THANKS!"