# 1
Curt Class III Ball Mount with 2" Ball - 2" Drop - 7,500 lbs
I ordered the Curt Ball Mount w/6"rise, 8" drop as I had a special need as my van had a lower hitch attachment than my full side truck. The Ball mount provided the exact clearance that I needed to tow as I was able to use the 6" rise side to raise the attachment point on my van. Very happy with my purchase.
The hitch and ball mount are excellent quality. My concerns are twofold. The hitch is so heavy that I had to take it to my mechanic to have it installed. Minor cost and inconvenience, but the hitch for my previous F-150 was just as sturdy, but easy to install myself (albeit with higher ground clearance). My concern about the ball mount is that the factory told me erroneously that it could not be reversed for a drop, so I returned it. This order is for the replacement after I was finally correctly told it could be reversed and how to do that. Ball mount would have been a 3 for that reason, and overall hitch and ball mount quality a 5. So I averaged them.
# 2
Curt Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs
Longer stinger let me drop the tailgate on my Tacoma with trailer attached. Replaced a similar but shorter Curt hitch and both are very substantial and well made for the weight of my trailer.
With good information from the website it was easy to order a Curt 2" Trailer Hitch, the Upgraded Circuit Protected Tail Light Converter Hardwire Kit w/ 4-Pole Connector and Circuit Tester - 119178KIT, Curt Ball Mount for 2" Hitches (3/4" Rise, 2" Drop - 10-1/4" Long - 7,500 lbs - D-4), Curt Pin and Clip Hitch Receiver - C21500, Rubber Tube Cover for 2" Trailer Hitch Receivers - I-728,Review, and 2" hitch ball 40038. Parts were delivered earlier than the initial estimate. Self installation (on a sloped drive way) took just under 2 hour. The fit of parts was very good, instructions and on-line video's were very helpful. My Kia did not have the wire plug in option, but the splice connections in the wire kit were easy to install. Most of the parts are hidden from view when the ball mount is not used.
# 3
Draw-Tite Ball Mount for 2" Hitches - 3/4" Rise, 2" Drop - 8-1/2" Long - 7.5K
Everything about my eTrailer experience has been absolutely first class, including the follow up emails, 2 of them. Due to a medical problem it's taken me over a year to complete the installation but that's on my end. I installed the hitch and wiring harness in May of 2016. I just now got to running the power wire up to the battery and finishing the job today, 8/2/17. Again, all due to issues on my end. The product, the personal assistance, and the videos made this job as easy as it could be for this 68 year old putting a hitch on a 2012 KIA Sedona by himself. Thanks to eTrailer for running a most excellent company in every regard.
Be aware that it is very difficult to get the nut on the ball tightened because it's hard to keep the whole thing from turning. Better to look for a receiver that has an indent machined where the base of the ball fits into the machined area to keep the ball from turning when tightening the nut.
What our customers are saying:
"wow! you guys are incredible. i guess this is why everyone on the Subaru forum recommends you. thank you so much for everything."